西门子MM440资料(第一部分）.pdfVIP

Drive technology MICROMASTER 4 Tips Tricks No: 0004 Subject Measuring the magnetizing current Description The motor should be commissioned according the procedure described in Section 3.5, Commissioning of the operating instruction. This guarantees that the required equivalent circuit diagram data of the motor match those specified on the motor rating plate. The following steps should always be carried-out: 1. Quick commissioning P0010=1 If the quick commissioning P0010=1 is exited using P39000, then the motor parameter P0340=1 is automatically calculated. In this case, equivalent circuit diagram data is calculated from the rating plate data which was entered. In addition, the closed-loop control parameters are pre-set. 2. Motor identification, Part 1 - P1910=1 The motor/feeder cable resistances, drive converter voltage losses and the leakage reactance are measured at standstill, and the main (magnetizing) reactance and the rotor resistance calculated, the closed-loop current control set. 3. Motor identification, Part 2 - P1910=3 In this case, the saturation characteristic of the magnetized reactance is measured. Generally, after these steps have been successfully completed, it is possible to accelerate the drive up to its rated speed. Depending on the motor being used and the mechanical configuration, it may be necessary to further optimize individual controllers. The feedback signals for the internal controller are dependent on calculated quantities – e.g. flux and speed actual value – from the motor model. This is true especially for sensorless vector control (P1300=20/22). However, the model only provides precise quantities if the equivalent