机械制造技术课程设计-高浓浆泵端盖的工艺及钻4-13孔夹具设计.docVIP

分 类 号 密 级 高浓浆泵端盖的工艺与钻4-13孔夹具设计 所在学院 专 业 班 级 姓 名 学 号 指导老师 年 月 日 关键词： 全套图纸，加 ABSTRACT The design is based on the body parts of the processing order of the processes and some special fixture design. Body parts of the main plane of the surface and pore system. In general, the plane guarantee processing precision than that of holes machining precision easy. Therefore, this design follows the surface after the first hole principle. Plane with holes and the processing clearly divided into roughing and finishing stages of holes to ensure machining accuracy. Datum selection box input shaft and the output shaft of the supporting hole as a rough benchmark, with top with two holes as a precision technology reference. Main processes arrangements to support holes for positioning and processing the top plane, and then the top plane and the supporting hole location hole processing technology. In addition to the follow-up processes individual processes are made of the top plane and technological hole location hole and plane processing. Supported hole processing using the method of coordinate boring. The whole process of processing machine combinations were selected. Selection of special fixture fixture, clamping means more choice of pneumatic clamping, clamping reliable, institutions can not be locked, so the production efficiency is high, suitable for large batch, line processing, can meet the design requirements. Key Words: box type parts process; fixture; 目 录 摘 要 II ABSTRACT III 第1章 绪论 1 1.1 机械加工工艺概述 1 1.2机械加工工艺流程 1 1.3夹具概述 2 1.4机床夹具的功能 2 1.5机床夹具的发展趋势 3 1.5.1机床夹具的现状 3 1.5.2现代机床夹具的发展方向 4 第2章 加工工艺规程设计 5 2.1 零件的分析 5 2.1.1 零件的作用 5 2.1.2 零件的工艺分析 5 2.2 高浓浆泵端盖加工的主要问题和工艺过程设计所应采取的相应措施 5 2.2.1 孔和平面的加工顺序 6 2.2.2 孔系加工方案选择 6 2.3 高浓浆泵端盖加工定位基准的选择 7 2.3.1 粗基准的选择 7 2.3.2 精基准的选择 7 2.4 高浓浆泵端盖加工主要工序安排 7 2.5 机械加工余量、工序尺寸及毛坯尺寸的确定 10 2.6确定切削用量及基本工时（机动时间） 11 2.7 时间定额计算及生产安排 21 第3章 钻4XΦ13夹具设计 27 3.1设计要求 27 3.2夹具设计 27 3.2.1 定位基准的选择 27 3.2.2