LTE中上行物理信道PUSCH.pptVIP

PUSCH PUSCH UCI in PUSCH PUSCH PUSCH transmission 1 bit indication in UL grant whether frequency hopping or not Localized transmission w/o frequency hopping Localized transmission with frequency hopping Hopping based on the hopping information in UL grant Hopping according to a predefined hopping pattern Inter/Intra Subframe PUSCH Hopping Set of PRBs to be used for transmission are given by UL scheduling grant If hopping with predefined hopping pattern is enabled, a predefined pattern is used When grant is absent, e.g., in cases of persistent scheduling and HARQ retransmission, UE follows the indication for hopping mode in the initial grant A single bit signaled by higher layers indicates whether PUSCH frequency hopping is inter-subframe only or both intra and inter-subframe PUSCH PUSCH PUSCH PUSCH PUSCH PUSCH PUSCH PUSCH PUSCH PUSCH PUSCH PUSCH PUSCH PUSCH PUSCH PUSCH PUSCH PUSCH PUSCH PUSCH PUSCH PUSCH * In case of PUSCH available, control signaling is multiplexed with data on PUSCH. –To cater for radio channel variation, link adaptation applies to data part –Control signaling does not adopt adaptive modulation but the size of Res (resource elements) can change w.r.t varying radio condition PDCCH There is a fixed schedule relation between PDCCH in down link subFrame and PUSCH uplink subFrame (36.213 8 Physical uplink shared channel related procedures) For example configuration 1 : In subframe 1 ,the DCI will carry the UL grant for subframe 7 In subframe 4 ,the DCI will carry the UL grant for subframe 8 is the PRB index of the 1st slot RA in subframe i lowest index PRB () of the 2nd slot RA in subframe i, is the total PUSCH resource blocks The offset used for PUSCH frequency hopping, expressed in number of resource blocks (set by higher layers) Uplink bandwidth configuration, expressed in multiples of Type 1 hopping Example (10MHz) subframe n ,hop =+1/2 Type 1 hopping Example (10MHz) subframe n ,hop =+1/4 Type 1 hopping Example (10MHz) subframe