现代住宅小区10kv0.4kv供配电系统设计(论文)【最新】.doc

现代住宅小区10/0.4KV供电系统设计 摘要 本次设计的课题是住宅小区10kV供电系统的设计。依据配电自动化的内容和国内外配电自动化的发展现状，本着“安全性、可靠性经济性我国现行的各有关规范规程等技术标准为依据，再根据任务书提供原始资料，参照有关资料及书籍，对各种方案进行比较而得出最为合适的方案。，短路电流计算，主要电气设备型号和参数的确定，无功补偿设计，防雷保护装置的设计供电系统，具有10kV和38个0V两电压等级，10kV一侧接与小区旁边经过的110kV变电站的10kV母线，380V主要用于小区用户的用电。 关键词短路计算无功补偿 THE POWER SUPPLY SYSTEM DESIGN OF RESIDENTIAL Abstract: The design of this residential area is the subject of the preliminary design of 10kV power supply system. The development present condition that contents and domestic and international power distribution that automates according to the power distribution automate. The power supply system designed is very important, if the system is broken, the entire residential area will affect the power supply, so the high reliability requirements. Therefore, the design must take into account the power system security, reliability and economy. With our country each current relevant specification regulations etc. technique standard is basis, again provide original data according to the task book, according to interrelated data and book, carry on compare vs various scheme but get most suitable scheme.This manual wiring through the residential load calculation, short circuit current calculation,the main electrical equipment to determine the model and parameters, reactive power compensation design, lightning protection and over voltage protection. The power distribution system step-down box-type substation with 10kV and 380V 2 a voltage, 10kV and 110kV substation side of the access bus 10kV, 380V electricity mainly for residential users. Keywords: box-type substation, short-circuit calculation, reactive power compensation, touchdown 目 录 摘 要 I Abstract: II 目 录 III 第1章 前 言 1 1.1 课题的国内外现状 1 1.2 设计范围 1 1.3 设计原则及标准 1 1.4 设计基本思路 3 第2章 住宅小区负荷的计算 4 2.1 概述 4 2.2 电源及高压供配电系统 4 2.3 负荷计算 5 2.4 电气负荷的计算 5 2.4.1住宅小区住户照明用电负荷计算方法： 5 2.4.2其它负荷计算方法： 6 2.4.3详细负荷计算： 7 第3章 短路电流计算 11 3.1 短路计算的目的及步骤 11 3.1.1短路电流计算的目的 11 3.1.2短路电流计算的一般规定 11 3.1.3短路电流的计算步骤 12 3.2 短路电流的计算 12 3.2.1短