薄板冷轧酸洗机组的分切剪设计机械本科毕业设计论文推荐.docVIP

内蒙古科技大学 本科生毕业设计说明书 题 目：薄板冷轧酸洗机组的分切剪 学生姓名： 号： 专 业：机械制造及其自动化 班 级：机械 05—2 班 指导教师：  内蒙古科技大学毕业设计说明书 薄板冷轧酸洗机组的分切剪 摘要 分切剪用来切去板材的头部和尾部大约 1.5 米的废板材， 长度， 知道预先选定的剪切次数达到后剪切才能完成， 成一次完整的剪切过程，， 个压力继电器的指示取决于液压缸活塞杆的位置，， 销机械锁紧，，，， ，， 作用下放松。刀座上安装着剪刃间隙调整装置， 刃间隙。 关键词：  I  内蒙古科技大学毕业设计说明书 abstract The dividing shear serves to crop the strip head as a function of a settable maximum number of cuts, as well as to chop the strip end, thereby producing about 1,5 m long scrap pieces. A tail-end optimization system determines the scrap-piece length at the strip tail. The scrap pieces will fall on the scrap discharge system belt and carried to the scrap chute on drive side of the line. Crop-cuts are carried out at the strip head until the pre-selected number of cuts has been reached The dividing-shear bottom knife accomplishes one complete cut upon each valve-coil excitation, comprising one upward motion of the bottom knife (= crosscutting of the strip) and subsequent opening of the dividing shear (= bottom knife down). The open position is indicated either by which depending on the position of the cylinder. for maintenance the shear can be mechanically blocked by means of a locking pin. This pin will have a fixed position when it is not locked in. This position will be monitored and is release condition for cutting.hydraulically operated knife clamping devices will facilitate knife changing and shorten changingperiods. Clamping is actuated by springs and will be released hydraulically. The released position ismonitored. The shear will be equipped with a gap adjustment, which must be adjusted according to a preset table depending on strip thickness and material quality. Key words：dividing shear Hydraulic gap adjustment  II  内蒙古科技大学毕业设计说明书  目 录 摘要 ......................................................................................................................................... Ⅰ abstract ......................................................................................