Machining Ti AI V alloy with a wBN cBN composite tool用复合工具加工合金.pdfVIP

See discussions, stats, and author profiles for this publication at: /publication/222483615 Machining Ti6Al4V alloy with a wBN-cBN composite tool ARTICLE in ATERIALS AND DESIGN · JANUARY 1995 Impact Factor: 3.5 · DOI: 10.1016/0261-3069(95)00044-5 · Source: OAI CITATIONS READS 60 118 3 AUTHORS, INCLUDING: Divakar Canchi Anil K. Singh National Aerospace Laboratories National Aerospace Laboratories 58 PUBLICATIONS 414 CITATIONS 214 PUBLICATIONS 3,311 CITATIONS SEE PROFILE SEE PROFILE Available from: Divakar Canchi Retrieved on: 22 February 2016 Machining Ti -6AI-4V alloy with a wBN-cBN composite tool S. K. Bhaumik, C. Divakar and A. K. Singh Materials Science Division, National Aerospace Laboratories, Bangalore-560 017, India Received 20 January 1995; accepted 7 December 1995 Titanium-based alloys are difficult-to-cut materials. The conventional tool materials (HSS and cemented carbides) fail due to the high chemical affinity of titanium and high temperatures generated while machining. An attempt has been made in this work to machine Ti-6AI-4V alloy with wurtzite boron nitride (wBN) based cutting tools. The mechanisms controlling the wear of the cutting tool have been found to be similar to those observed in polycrystalline diamond (PCD) and polycrysta