车库门设计系统C源程序清单.docVIP

车库门设计系统C源程序清单 系统源程序： #includeAT89X51.H #define uchar unsigned char #define uint unsigned int uchar cnt,flag,cnt1; uchar ps[]={1,2,3,4,5}; uchar code dispbit[]={0xfe,0xfd,0xfb,0xf7, //动态扫描8位位选 0xef,0xdf,0xbf,0x7f}; uchar code dispcode[]={0x3f,0x06,0x5b,0x4f,0x66, 0x6d,0x7d,0x07,0x7f,0x6f, 0x77,0x7c,0x39,0x5e,0x79,0x71, //0--F共阴 0x00,0x40,0x73,0xff}; // 0x40为- ，0x73为P //16对应0x00，即删除时让数码管熄灭，19对应0xff，即显示该位密码数据时让数码管连着小数点一起全亮即8. uchar dispbuf[8]={18,16,16,16,16,16,16,16}; //此处18对应P.16 是让其他7位数码管熄灭 //?为什么16就熄灭，我输9，12，就显示9和12.为什么18就是显示P,因为是dispcode[dispbuf[dispcount]]，相当于dispcode[dispbuf[18]]=0x73=P uchar dispcount; uchar flashcount; uchar temp; uchar key; uchar keycount; uchar pslen=5; uchar getps[6]; bit keyoverflag; bit errorflag; bit rightflag; uint second3; uint aa,bb; uint cc; bit okflag; bit alarmflag; uchar oka,okb; sbit led=P3^6; sbit keyhong=P3^2; sbit keykong=P3^7; sbit VT=P3^3; void delay(uint z)//1ms { uint x,y; for(x=z;x0;x--) for(y=110;y0;y--); } void keyscan() { uchar i; P1=0xff; P1_4=0; temp=P1; temp=temp 0x0f; if (temp!=0x0f) { delay(5); temp=P1; temp=temp 0x0f; if (temp!=0x0f) { temp=P1; temp=temp 0x0f; switch(temp) { case 0x0e: key=7; break; case 0x0d: key=8; break; case 0x0b: key=9; break; case 0x07: //第一列7，8，9，10 key=10; break; } temp=P1; // P1_1=~P1_1; if((key=0) (key10)) //如果键值为一位数字则使该位dispbuf[keycount+2]=19，能否显示还要做一些处理 {