5线传感器的应用.docVIP

当使用一个5线（宽带）传感器，我们做出关于该传感器用于环境的某些假设，例如我们假设该传感器用于测量比较完善的排气燃烧的副产品。 When using a 5-wire (wideband) sensor we make certain assumptions about the environment the sensor is used in, for example we assume the sensor is used to measure the exhaust byproducts of fairly complete combustion. 燃烧可以是内部的，如在传统汽车或外部燃烧，如在炉或其他设备消耗燃料和氧气。 The combustion can be internal, as in a conventional vehicle or external combustion, as in a furnace or other device consuming fuel and oxygen. 如果这些条件改变后可能会导致不适当的读数。 If these conditions are altered then inappropriate readings may result. 例如，如果错过，火灾发生和未燃烧的燃料液滴穿过电机，然后传感器将读取瘦，因为它不会检测液体燃料。 For example, if a miss-fire occurs and unburnt droplets of fuel go through the motor, then the sensor will read lean as it will not detect the liquid fuel. 当调谐到一辆车，你不应该完全依赖于从一个传感器读数。 When tuning a vehicle, you should not rely solely on the reading from a sensor. 让你的常识，以及如何传感器工作，引导你所知甚少。 Let your common sense, and a little knowledge of how the sensor works, guide you. 宽带传感器需要一个控制器，因为它们比标准的窄带传感器复杂。 Wideband sensors require a controller because they are more complex than a standard narrowband sensor. 他们更准确的，因为这种复杂性，但这意味着他们需要一个技术复杂的控制器，他们在所有的工作。 They are more accurate because of this complexity, but this means they require a technically complex controller for them to work at all. 而传感器本身可以被认为是两个紧密相连的是一个沉闷的电加热到热读部分： The sensor itself can be thought of as two closely connected parts that are electrically heated to a dull read heat: 窄带传感器探测到一个小厅的氧气浓度。 A narrow-band sensor to detect the oxygen concentration within a small chamber. 甲泵输送氧离子电池，或从这个小室的表面。 A pump cell that transports oxygen ions to or from the surface of this small chamber. 正如我们将会看到，宽带传感器是由电流是流入或流出泵细胞泵浦的宽带电子控制器。 As we will see, the wideband sensor is operated by current that is pumped into or out of the pump cell by the wideband controller electronics. 这是根本不同的传感器，产生一个窄带的窄带电压，无需任何外部电子设备，当加热到工作温度。 This is fundamentally different to a narrowband sensor that produces its narrowband voltage, without any external electro