多孔隙圆柱於明渠中之三维流场模拟-中华水土保持学会.PDFVIP

中華水土保持學報, 46(4): 239-251 (2015) 239 Journal of Chinese Soil and Water Conservation, 46 (4): 239-251 (2015) 多孔隙圓柱於明渠中之三維流場模擬 許少華 [1] 辛為邦[1]* 洪碧芳[2] 摘 要 本研究使用 FLUENT 進行多孔隙圓柱之三維明渠流流場模擬。分別以大渦模擬 (Large Eddy Simu- lation, LES) 及標準 k- ε紊流模式兩種方式，皆搭配體積分率法 (Volume of Fluid, VOF) 進行有自由液面之紊 流模擬。觀察不同孔隙率之多孔隙圓柱於半浸沒 (常水位) 和浸沒條件 (高水位) 下，圓柱周圍之流況。並討 論使用「實體外型框邊」與「數值摩損框邊」 兩種不同方式設置圓柱邊界條件時對流場之影響。由模擬結果 得知，不透水圓柱與低孔隙率圓柱皆存在馬蹄形渦流、上升流以及卡門渦街等現象，隨著圓柱孔隙率增加， 馬蹄形渦流等流況漸漸消失。於低孔隙率時，LES 之模擬結果較標準 k- ε紊流模式能顯示出圓柱周遭之渦度 變化，中、高孔隙率時，兩者差異甚小。比較實體外型框邊與數值摩損框邊之流場差異，實體外型框邊圓柱 於柱後流速回復較快，數值摩損框邊圓柱則會產生柱後低速區過長之情況，後者會高估現場設置多排孔隙圓 柱之適當間距。 關鍵詞：多孔隙圓柱、數值模擬、LES 、k- ε、FLUENT 。 A 3-D Numerical Simulation of the Flow Field around a Porous Cylinder Shao-Hua Marko Hsu[1] Wei-Bang Hsin[1]* Pi-Fang Hung[2] ABSTRACT The three dimensional flow field around a single porous cylinder within an open-channel flow is simulated using a FLUENT model and CFD software. Large eddy simulation (LES) and standard k-ε turbulence models, both of which use the volume of fluid (VOF) to trace the free surface, are used to generate turbulence in the simulation. The experimental data is used to verify and to calibrate parameters. A non-immersion condition and an immersion condition are respectively used to represent a general field case and a case with high flow. Cylinders with different degrees of porosity are tested. Two types of internal boundaries are used to represent the porous material, the physical structural frame and the numerical frictional frame and their deviation in the flow field is discussed.