完全燃烧混合物.pptVIP

Air Pollution Control Engineering Prof. Jiakuan Yang Huazhong University of Science and Technology Lecture 7-1 General ideas in air pollution control Questions for the Last Lecture Answer (1) Answer (2) Answer (3) Ⅴ Efficiency, penetration, nines Ⅴ Efficiency, penetration, nines Ⅴ Efficiency, penetration, nines Ⅴ Efficiency, penetration, nines Ⅵ Homogeneous and non-homogeneous pollutants Ⅶ combustion Ⅶ combustion Ⅶ combustion (3) Explosive or combustible limits Ⅶ combustion (3) Explosive or combustible limits Ⅶ combustion (3) Explosive or combustible limits Ⅶ combustion LEL and UEL often are expressed in the ratio of the mole percent of methane in the limit mixture to that in the stoichiometric mixture. Ⅶ combustion (3) Explosive or combustible limits Ⅶ combustion (3) Explosive or combustible limits Ⅶ combustion products change Ⅷ Changing Volume Flow rate Ⅷ Changing Volume Flow rate Ⅷ Changing Volume Flow rate Ⅷ Changing Volume Flow rate Ⅷ Changing Volume Flow rate Ⅷ Changing Volume Flow rate This Lecture and the Next Lecture Exerciser DISCUSSION * Ⅰ Three alternative for air pollution control Ⅱ air pollution control systems and equipment Ⅲ Fluid velocities in air pollution control equipment Ⅳ Minimizing volumetric flow rate and pressure drop Ⅴ Efficiency, penetration, nines 1. What are three alternatives for air pollution control? 2. Please give three logical approaches to improving dispersion. 3. How to deal with the collected pollutants in down-stream pollution control device? Process change and pollution prevention Down-stream control device Improving dispersion Tall stack Intermittent control schemes Relocate the plant Reuse the collected pollutants if the concentration is high enough to recovery, such as, raw materials, fuels Ultimate disposal of the rest pollutants by landfill or combustion. Downstream control device C0 Q1C1 Q0C0 C1 Q0C0 Mass flow rate of contaminant into the device Q1C1 Mass flow rate of contami