轴系安装交验项目.docVIP

Inspection items for 3500T shaft system installation after launching 3500T散货船下水后轴系安装交验项目 Note: Surveyor and owner can make some necessary increase or decrease for the inspection items according different requirement. definition for the mark in the form O: owner representative attend item C: surveyor attend item R: the test report should be submitted to surveyor and owner 3. The data for bearing load jacking-up test should be approved by BERG 说明： 本项目船检、船东可按不同要求对交验项目作必要的增减。 交验项目表中的符号解释 O: 需船东代表参加的项目 C：需验船参加的项目 R： 需向验船师、船东代表提供的试验记录报告 轴承负荷顶升报检数据需向BERG认可 no. Inspection Items 验收项目 Inspection time 验收阶段 C O R Remark备注 1 The position of stern shaft and fore seal double-check 尾轴与首密封位置复查报检 Before alignment inspection 对中报检前 √ √ √ 2 Stern shaft and G/B shaft line alignment 尾轴与齿轮箱轴线对中报检 Before drill hole 钻孔前 √ √ √ Drill the holes of G/B foundation, if the alignment data is ok. 3 M/E absorber foundation installation 主机减震器底座安装 During construction 施工中 √ √ All bolts that torque required 所有有扭力要求的螺栓 4 Measuring the data of absorb block 减震块数据测量 48hours after absorber loading 减震器加载48小时后 √ √ √ 5 First jacking-up test 第一次轴承负荷顶升报检 During construction 施工中 √ √ √ Only do at after peak TK full condition 只做尾压载舱满舱状态 6 Measure dimension of stern shaft coupling bolts 尾轴联轴节螺栓尺寸测量 Before construction 施工前 √ √ √ 7 Measure dimension of G/B coupling reamed hole 齿轮箱联轴节铰孔尺寸测量 After construction 施工后 √ √ √ 8 PT for G/B coupling reamed hole 齿轮箱联轴节铰孔着色探伤 After construction 施工后 √ √ 9 Stern shaft and G/B coupling bolts installation 尾轴与齿轮箱联轴节螺栓安装报验 During construction 施工中 √ √ 10 Stern shaft and G/B coupling bolts torque inspection 尾轴与齿轮箱联轴节螺栓扭力报检 24hours after installation 安装24小时后 √ √ 11 M/E and G/B shaft line alignment 主机与齿轮箱轴线对中报检 Before drill hole 钻孔前 √ √ √ Drill the holes of M/E foundation, if the alignment data is ok. 12 Shaft gen. and G/B shaft line alignment 轴带发电机与齿轮箱轴线对中报检 Before dr