- 88
- 0
- 约3.88千字
- 约 16页
- 2018-05-19 发布于四川
- 举报
Temperature Test For Luminaires UL 1598 2nd Edition and CSA C22.2 No. 250.0-24 Presented by Ms. Shelley Liu (1 March, 2006) Scope Of UL 1598 ﹝UL1598的範圍﹞ Latest Version of UL 1598 is Second Edition dated December 30, 2004. It was co-published by both UL and the Canadian Standards Association (CSA). It reflects the requirements of the US and Canada. ﹝UL1598之最新版本為2004年12月30日發行的第二版。此標準是由UL及CSA共同出版,故可同時反映美國及加拿大的要求。﹞ Scope Of UL 1598 (Cont’d) ﹝UL1598的範圍﹝續﹞﹞ Requirements according to Mexican National Electrical Code, NOM-001-SEDE are added in this edition for reference. ﹝加入墨西哥的要求NOM-001-SEDE 以為參考。﹞ UL 1598 applies to luminaires for use in non-hazardous locations that are intended for installation on branch circuits of 600?V nominal or less between conductors. ﹝UL1598適用於接駁至600伏或以下分支電路,並安裝在非高危地方的固定式燈具。﹞ Scope Of UL 1598 (Cont’d) ﹝UL1598的範圍﹝續﹞﹞ Not apply to ﹝不適用於:﹞ - Stage and Studio Luminaires (UL 1573) ﹝舞台燈具及攝影燈具﹞ - Self-ballasted lamps (UL 1993) ﹝節能燈﹞ - Exit fixtures (UL 924) ﹝出口固定式燈具﹞ - Luminaire fittings used in hazardous locations (UL 844)﹝於高危地方使用的燈具﹞ Tests (UL 1598 CSA C22.2 No. 250.0) Normal Temperature Test﹝溫升測試﹞ Dielectric Voltage-Withstand Test ﹝耐壓測試﹞ Bond Impedance ﹝聯結阻抗測試﹞ Loading ﹝負重測試﹞ Movable Joint Rotation ﹝可移動關節轉動測試﹞ Strain Relief ﹝拉力測試﹞ Rain Test ﹝淋雨測試﹞ Sprinkler Test﹝灑水測試﹞ Normal Temperature Test (Cont’d) ﹝溫升測試﹝續﹞﹞ Sample shall be mounted in the intended manner. ﹝樣品將以其預設的方式安裝﹞ Supply conductor temperature measured by temperature test probe. ﹝供電導體溫度需以溫升測試探針量度﹞ Surface temperature shall be measured by thermocouple. ﹝表面溫度需以熱電偶量度﹞ Winding temperature shall be measured by change of resistance method. ﹝線圈溫度需以電阻差的方法量度﹞ Normal Temperature Test (Cont’d) ﹝溫升測試﹝續﹞﹞ Supply conductor temperatures in the outlet box shall be measured using the temperature test probe. ﹝供電導體溫度需以溫升測試探針量度﹞ Measured temperature (corrected to 25°C) shall not exceed the limits specified in Table 14.1.2. ﹝校正至25攝氏度之量度溫度不得大於表14.1.2內所列明之數值﹞ Shall be followed by Dielectric-Vol
原创力文档

文档评论(0)