65Mn激光硬化表面土壤磨损试验.pdfVIP

65Mn 激光硬化表面土壤磨损试验 ， 1 2 陈卓君 ,张祖立 （1. .沈阳理工大学 汽车与交通学院 浑南新区南屏中路 6 号 110168 2 沈阳农业大学 农业工程学院，沈阳市东陵路 120 号 110161） 摘 要：通过土壤磨损实验考察了激光强化工艺参数对 65Mn 旋耕刀基体显微硬度的影响， 获得 65Mn 旋耕刀基体激光强化处理的最佳工艺参数。在激光功率为 1400W、扫描速度为 16mm/s 和为激光功率 1500W、扫描速度为 18mm/s 的条件下，磨损率较小，在壤土、沙土 和粘土三种土壤中进行磨损试验, 沙土中的磨损率最小 激光表面处理 65Mn 在土壤实验条 件下耐磨性比较，实验结果表明： 65Mn 经过激光处理其表面耐磨性比一般淬火的表面 的最大耐磨性提高 5 倍。65Mn 表面磨损主要是磨粒磨损，激光处理 65Mn 表面可以 提高表面硬化层的硬度，同时可以提高材料的耐磨性，增加 65Mn 的寿命。即经过激 光处理后 65Mn 的耐磨性都比淬火得到大大提高。土壤压力时增大磨损率增大。 关键词： 激光强化，9SiCr，显微硬度，土壤磨损 The research of 9SiCr by laser hardening surface in soil wear Chen zhuojun1 Zhang Zuli,2 (1 Auto and Traffic Institute Shenyang Ligong University,Shenyang 110168, 2 China School of Agricultural Mechanization Engineering,,Shenyang Agricultural University Shenyang 110161,China, chenzhuojun@ ,sauzhangzl@;) Abstract ： Through experimental of soil wear for process parameters of laser 65Mn blade microhardness influence matrix, 65Mn blade matrix by laser hardening of the optimal parameters. When the laser power is 1400W and scanning velocity16mm/s and laser power is1500W, scanning velocity is 18mm/s ,wear rate in loam, and sand soil and clay soil in three wear test, the rate wear is the most minimum in sand soil .Experimental results show that surface treatment of 65Mn by laser in soil, laser processing its surface resistance of surface hardening of 65Mn than the maximum resistance to improve 5 times. Abrasive wear is mainly on surface, of 65Mn , laser treatment can improve in the depth of hardening layer, can also improve the resistance of the material 。 The surface of 65Mn is mainly abrasive wear, surface by laser pr