项目管理图片说明书.ppt

All the o-ring grooves have be examined. And This tool’s o-ring grooves don’t be broken. And the steel isn’t too thin. We’ll modify the several in it. And take the photoes afterwards. * Tool Eject plate pry bar * Tool Eject system, used the self- lubricate guide bush * Tool The back surface of the eject plate * Tool All the eject pins have the marriage marks * Tool Except 2 eject pins, all the eject pins used the Hasco original components * Tool Only 2 eject pins used the LHM components * Tool The hardness for the ware plate, waiting for Alba to approve * Thank you !!! * Tool The back surface of the Cav insert 1. * Tool Cavity insert 1 cooling system, have the steel waste inside, please clean it for all the tools closed * Tool All the inserts have the marriage marks for the cavity side * Tool Cavity insert 2, front surface * Tool Cavity insert 2, back surface * Tool The cooling line should be change, don’t put at the end of the holes, please use the other way for the baffle. closed * Tool Hot tip, no damage, no raw material leakage. * Tool A plate * Tool Some ware plate have the marriage marks. Please make sure all the ware plate have the marriage marks. * Tool Insulate plate, need to be change , once add the top clamp plate * Tool Hot runner system * Tool No found the water channel for the hot runner system, please make it at the tool bottom side closed * Tool Hot runner connect way, not complete yet * Tool Core side * Tool Have the cover for eject plate * Tool Tool disassembly * Tool Eject return plate * Tool B plate, back surface * Tool Core side, P/L side * Tool B plate * Tool O –ring steel is too thin, Don’t make the round at the corner, waiting for Alba feedback. closed * Tool Don’t use the DME or Hasco original side locker for this tool closed * Tool Core insert 1, no welding mark * Tool Need to check the cooling line, have water leakage at the plug region closed * Tool Core insert 1, the back surface * Tool The marriage marks is wrong, please corre