【CT431】自动控制中心传动提耙式刮泥机【提升】设计说明书.docVIP

摘　　要 自动提耙刮泥机驱动装置是在机械回转传动设备中一种新型的过载自动提升装置，，，， 本装置正是基于上述情况而设计的一种自动过载提耙—落耙连续运转的刮泥机驱动装置。其工作原理：，(当驱动电机电流增到一定数值)电流继电器发出信号驱动电机停机—启动抬耙电机达到一定高度停机—启动驱动电机—让过过载区(利用延时装置)后启动抬耙电机落耙到原始位置停机，，， 本装置运用PLC自动控制系统实现驱动电机停机—启动抬耙电机达到一定高度停机—启动驱动电机—让过过载区(利用延时装置)后启动抬耙电机落耙到原始位置停机这一运转过程。在污水系统的初沉池和浓缩池处理中，，，， 自动提耙结构设计部分，通过分析研究各种自动提耙结构的优缺点来设计中心传动自动提耙装置。自动提耙装置安装在中心传动刮泥机顶部，它靠电磁继电器将刮耙装置提起，调节刮耙高度依靠增加或减少电磁继电器电流来实现。它能保持电流恒定，但实际上对于大多数自动提耙装置而言，由于提耙装置本身就有摩擦阻力存在，有死区产生，但死区范围不是太大，可以完全起到应有的提升作用，且工作的可靠性最强。适用于上升、旋转、下降，对使用环境没有特殊的要求。 关键词：回转轴承； ； ； ； Abstract It is a kind of new overload voluntarily promotion installation in mechanical rotary transmission to mention harrow voluntarily to scrape mud machine actuating device， should install can make equipment overload occur ，will harrow promotion so let overload district，and return position voluntarily. Realization does not be disconnected continuously to operate，eliminate overload area voluntarily step by step. Install is just based on above-mentioned condition design a kind of automatic overload mention harrow — fall to harrow succession operation scrape mud machine actuating device. Its working principle：Through current relay mensuration drive generator current， determine overload ( will drive generator current increase certain value ) current relay send signal drive generator stop machine — start to lift harrow generator reach stop surely highly machine — start drive generator — let overload district ( use the installation of delay time ) after start to lift harrow generator fall harrow go to original location stop machine，completion is a and overload to start cycle，wait next cycle ，scrape overload district step by step via some cycles to level. Install to utilize PLC voluntarily control system realization drive generator stop machine — start to lift harrow generator reach stop surely highly machine — start drive generator — let year district ( use the installation of delay time ) after start to lift harrow generator fall harrow go to original location stop mac