- 7
- 0
- 约1.5万字
- 约 25页
- 2018-07-14 发布于浙江
- 举报
PAGE \* MERGEFORMAT IV大连海林博格机电设备有限公司恒压供水系统项目调研报告摘 要随着社会的进步,人们对生活质量的要求也在不断的提高,水的使用更是生活中不可缺少的一个环节,人们也开始越来越重视供水,随之发展而来的供水系统也变得尤为重要,但是近年来,能源的不断减少,使人们开始意识到节水节能的重要性,这就要求供水系统要不断的改善与进步,恒压供水系统因为拥有先进的自动化技术,控制技术成为了目前可以满足人们要求的一种供水系统,也是目前使用最为广泛的的供水系统。本文主要论述了以可编程逻辑控制器(PLC,Programmable Logic Controller)和变频器为基础的恒压供水系统,恒压供水系统可以根据用水量的需求来自动调节供水量,保持水量的恒定来满足要求,从而达到节能的作用。恒压供水系统使用交流接触器,变频器,电动机,4-20mA的信号发生器,PLC来模拟实现,通过外部的压力信号与预先给定PLC的额定压力值进行对比,将输出信号传送给接触器,使接触器吸合从而使变频器控制电机的转速来达到供水系统的模拟。关键词:恒压,变频器 ,电动机 , PLC大连东软信息学院毕业设计(论文) AbstractInvestigation Report of Constant Pressure Water Supply System Project for Dalian Hylinberg Mechatronic Equipment Co.,Ltd. AbstractWith the progress of society, peoples quality of life requirements also in unceasing enhancement, the use of water is also apart of life ,people began to pay more and more attention with the development of water supply, water supply system and also becomes more and more important. but in recent years, continuously to reduce energy, so that people are beginning to realize the importance of saving water and energy, which requires the water supply system to continuous improvement and progress, the constant pressure water supply system with advanced automation technology, control technology currently has become a water supply system can meet the requirement of people, is currently the most widely used for the water supply system. This paper mainly discusses the programmable logic controller (PLC,Programmable Logic Controller) and frequency converter based on constant pressure water supply system, constant pressure water supply system can automatically adjust the water supply according to the water demand, maintain water constant to meet the requirements, so as to achieve energy-saving effect. In this paper, the use of AC contactor, frequency converter, motor, 4-20mA signal generator, PLC to simulate a set of constant pressure water supply system.Constant pressu
您可能关注的文档
- 本科论文设计-x86保护模式下简易操作系统的设计与实现.doc
- 本科论文设计-便携式酒精浓度检测仪设计与实现.doc
- 本科论文设计-3D光立方设计与实现.doc
- 本科论文设计-多路数字电压表设计与仿真.doc
- 本科论文设计-多功能盲人电子表设计与实现.doc
- 本科论文设计-高压垂直双扩散MOS器件的设计与实现.doc
- 本科论文设计-歌曲比赛抢答系统设计与实现.doc
- 本科论文设计-高性能霍尔开关电路设计与验证.doc
- 本科论文设计-公交语音报站系统的设计与实现.doc
- 本科论文设计-红外遥控电风扇的设计与实现.doc
- 中国国家标准 GB/Z 37551.300-2026海洋能 波浪能、潮流能及其他水流能转换装置 第300部分:河流能转换装置发电性能评估.pdf
- GB/T 44937.3-2025集成电路 电磁发射测量 第3部分:辐射发射测量 表面扫描法.pdf
- 中国国家标准 GB/T 44937.3-2025集成电路 电磁发射测量 第3部分:辐射发射测量 表面扫描法.pdf
- 《GB/T 44937.3-2025集成电路 电磁发射测量 第3部分:辐射发射测量 表面扫描法》.pdf
- 中国国家标准 GB/T 44937.1-2025集成电路 电磁发射测量 第1部分:通用条件和定义.pdf
- GB/T 44937.1-2025集成电路 电磁发射测量 第1部分:通用条件和定义.pdf
- 《GB/T 44937.1-2025集成电路 电磁发射测量 第1部分:通用条件和定义》.pdf
- 中国国家标准 GB/T 4937.37-2025半导体器件 机械和气候试验方法 第37部分:采用加速度计的板级跌落试验方法.pdf
- 《GB/T 4937.10-2025半导体器件 机械和气候试验方法 第10部分:机械冲击 器件和组件》.pdf
- 中国国家标准 GB/T 44937.2-2025集成电路 电磁发射测量 第2部分:辐射发射测量TEM小室和宽带TEM小室法.pdf
原创力文档

文档评论(0)