本科论文设计-多路数字电压表设计与仿真.docVIP

PAGE \* MERGEFORMAT IV多路数字电压表设计与仿真摘 要随着电子科学技术的发展，电子测量成为广大电子工作者必须掌握的手段，对测量的精度和功能的要求也越来越高，而电压的测量甚为突出，最为普遍。本设计是采用AT89C52单片机作为主控制器的多路数字电压表，该电路采用ADC0809作为A/D转换元件，可进行0～5V的8路电压信号的采集，电压可以精确到小数点后两位有效数字。能够通过两个按键开关选择输入通道，并在LCD1602液晶显示屏上依次显示每路通道电压值，显示屏上第一行显示通道数，第二行显示电压值。本设计电路结构简单，采用的元器件较少，成本低，经济实用，相比于老式指针电压表更直观准确，无视觉误差，大大的提高了测量的精确度。关键词：单片机，电压表，A/D转换大连东软信息学院毕业设计（论文） AbstractDesign and Implementation of Multi-Channel Digital Voltmeter Based on MCUAbstractWith the development of science and technology, electronics, electronic measuring workers must master to become the majority of electronic means of measurement accuracy and functionality requirements are also increasing, and voltage measurements are very prominent, the most common. This design is using AT89C52 as the main controller of multi-channel digital voltmeter, the circuit ADC0809 as A / D conversion device can be collected 8 0 ~ 5V voltage signal, the voltage can be accurate to two decimal places valid numbers. Can be selected by two key switch input channels, and each channel in turn displays the voltage on the LCD1602 LCD screen, the first line shows the number of channels, and the second line shows the voltage value. Design a simple circuit structure, fewer components using low cost, economical and practical, compared to the old-fashioned pointer voltmeter is more intuitive and accurate, no visual error, which greatly improves the accuracy of the measurement.Key words: MCU, Voltmeter，A / D converter 大连东软信息学院毕业设计（论文） 目录目 录 TOC \o 1-3 \u 摘 要 PAGEREF _Toc341622768 \h IAbstract PAGEREF _Toc341622769 \h II第1章　项目概述 PAGEREF _Toc341622770 \h 11.1项目背景 11.2项目简介 11.3应用范围 1第2章　项目实施方案 22.1概述 22.1.1设计方案 22.1.2主要芯片介绍 22.2开发环境 72.3硬件设计 72.3.1硬件系统框图 72.3.2硬件设计原理 82.4　软件设计 102.4.1主流程图 102.4.2 A/D转换子程序流程图 112.4.3显示子程序流程图 11第3章　项目实施过程 123.1硬件实现过程 123.1.1Altium Designer环境简介 123.1.2Altium Designer设计原理图 123.2软件实现过程 143.2.1Keil开发环境介绍 143.2.2源程序代