基本功能讲解ppt课件.pptVIP

3DNS可以选择多种测试方法判断对local DNS的RTT时间, 包括: DNS_Dot: 向local DNS发起一个包含”.”的测试, 也就是向目标LocalDNS请求root清单，该解析一般默认配置的DNS服务器均提供支持。 DNS_REV: 向local DNS发起LocalDNS本机IP的PTR请求 UDP:发起一个UDP的包, 看是否回应 TCP:发起一个TCP的包看是否回应 ICMP:发起一个ICMP 的ping 包, 看是否回应 3DNS可以选择多种测试方法判断对local DNS的RTT时间, 包括: DNS_Dot: 向local DNS发起一个包含”.”的测试, 也就是向目标LocalDNS请求root清单，该解析一般默认配置的DNS服务器均提供支持。 DNS_REV: 向local DNS发起LocalDNS本机IP的PTR请求 UDP:发起一个UDP的包, 看是否回应 TCP:发起一个TCP的包看是否回应 ICMP:发起一个ICMP 的ping 包, 看是否回应 表中可以看出，对于同一个站点，一个用户分别从两条线路进行访问，得出的访问速度差异是非常大的。最大的差值在广东电信分别访问站点的两条线路，其速度差异接近20倍。 换成双机热备的网络拓补图 注意强调新旧体系的差异性，V9新的体系对 应用转换与优化 做了极大的改进，为F5相对于其他产品的优势 The above slide illustrates how Intelligent Traffic Control gives you more granular control over how connections are distributed. A client connecting to a service hosted behind a BIG-IP controller will use DNS to determine the IP address to connect to. To connect to the service, the client needs to connect to a specific port on that IP address. Prior Intelligent Traffic Control, BIG-IP would manage network traffic solely on these two parameters. Intelligent Traffic Control allow BIG-IP to use additional information to determine which node is the most appropriate to handle an incoming request. Please note that pools and rules are covered more extensively in the BIG-IP advanced training. ? Extended Application Verification (EAV) is intended to provide maximum flexibility. An external service program works in conjunction with the bigdnode daemon, which verifies node status using node pings and services checks. If you configure external service check on a specific node, the bigdnode daemon checks the node by executing the external service checker program and looks for output written by the external service checker. If the bigdnode finds output from the external service checker, it marks the node up. If it does not find output, it marks it down. The external checker service program must follow the next steps: Must use a pid file to hold its process id /var/run/pinger.ip.po