燃煤锅炉高效改气技术分析及数值模拟-analysis and numerical simulation of high efficiency gas reforming technology for coal-fired boilers.docxVIP

Abstract Abstract Abstract With the strengthening of energy saving, emission reduction and strengthening of development, utilization of natural gas resources, plus the increasing contradiction between national energy demand and environmental pollution, coal-fired boilers cannot meet the future development demand of our country. While, by using natural gas and this kind of clean energy that is of low pollution and high-effective combustion, pollution can reduced effectively, so it is very helpful to build a environment-friendly society. Compared with buying a new gas-fired boiler, reconstructing existed coal-fired boilers to gas-fired ones is even cheaper, so for enterprises and companies, when needing to change coal-fired boilers to gas-fired boilers, “coal-to-gas” technology is practical and effective, and it should be the first choice. At present, researches on coal-to-gas technology mostly stay on experience discussion or partial research, and there are few theoretical and quantitative researches on critical technology of “coal-to-gas” method, so quantitative data that used for guiding the coal-to-gas design scheme is lacking. Comparing with experimental research, numerical simulation studies can not only lower the cost, but also can obtain the thermal parameters of reconstructed boilers, it is very helpful for further optimization to the boilers’ structure. In this paper, considering the SZL15-1.25-AⅡchain grate coal-fired boiler as the research object, the researches are carried out from the following aspects: First of all, the restructuring cost for coal-to gas technologies is analyzed and compared. The results show that when the basic structure of the boiler isn’t changed, namely removing the coal-scuttle, the front arch and the rear arch, extending the front wall to the forefront of the fire grate. After sealing, the gas boiler furnace is formed. The area of the radiant surface and the radiation ability are greatly increased, and the restructing cost is lowe