宝钢1580pc轧机零调偏差控制研究-机械设计及理论专业论文.docxVIP

万方数据 万方数据 Abstract 1580PC mill introduced by BaoSteel company is a new type of hot rolling mill, and it can effectively control the profile and crown. It has advantages as below:large range and high accuracy to control the strip crown;control the strip profile infinitely. However,as the output has gradually increased,the equipment under the high-load critical state for a long time, equipment deterioration trend is intensified obviously,roll zeroing precision and rolling stability are gradually lower.Excessive force deviation when roll zeroing,roll gap deviation after roll zeroing, often seriously affected production. This paper will do research on the problems of excessive deviation of rolling force on two sides of the rolling mill when roll zeroing of the BaoSteel 1580PC mill. Firstly, on the base of previous study researching the whole roll zeroing process.By analysing the gap impact on the roll system state, obtain the work roll with backup roll and work roll with work roll crossing system state when gap exists.Talk about the reason for static deviation from mill rigidity,vertical direction deviation,hydraulic screw-down system,roll system’s crossing and so on;Talk about dynamic deviation from axial force on the roll.And the same time use theory of preliminary displacement to calculate the axial force produced by roll crossing when roll zeroing. Using the finite element software ANSYS to calculate the static deviation caused by work roll and backup roll crossing under different gap state,and the dynamic deviation caused by different cross angle when rolling. The conclusion indicate that the main reason for unparallel gap is dynamic force deviation ,while the main reason for dynamic deviation is unparallel roll system.As for this problem,this paper issued controlling the rigidity difference III and dimension difference in vertical direction of the roll system and a new method which is Cross Head Gap Self-Compensated. In theory analysis,when roll chock and the