（毕业学术论文设计）-吹吸机风扇模具设计与模流分析论文.docVIP

PAGE II l 橡胶成形模具综合实验开发 吹吸机风扇模具设计与模流分析 摘 要 本文主要介绍了吹吸机风扇塑料件的注射模设计，其材料为PA6。根据PA6塑料的工艺特性和产品的使用要求，分析了吹吸机风扇的结构特点和成型工艺。通过应用Moldflow软件对塑件进行模流分析的结果，可作为确定塑件的注射模结构以及工作过程的参考。采用PRO/E软件进行3D分模，对模具进行了成型零部件、浇注系统、侧向抽芯机构、推出脱模机构及冷却系统的设计分析。在运用EMX4.1加载模架时，本设计加载的是国产龙记模架，在运用AutoCAD绘制工程图时利用了Ltools 4.1插件,该插件里集成了大量包括龙记模架在内的国产模架，能较大程度上实现了三维设计与二维设计的统一，并且也极大的提高绘图效率。 关键词：吹吸机风扇，注射模设计，模流分析  The injection mold design of the Fan Abstract This paper describes the injection mold design of the fan. The material of the fan is PA6. According to the processing property of PA6 and the product’s operating requirement. The structure and manufacturability of the fan was analyzed. Through making use of MoldFlow software to flow simulate analyses an injection mould structure and its operating process was determined. Making use of Pro/E system to set up 3D mold opening, designing the molding part, runner system cross range ejecting mechanism, reset mechanism and the cooling system. Making use of Moldflow software to analysis in order to trial your designing process. EMX4.1 loaded in the use of mold, the case load is made in mind moldbase Long, at the same time in the use of AutoCAD to draw engineering drawings using draw the Ltools 4.1 plug-ins, the plug-in integration, including a large number of mold-long recorded in the made within the mold, to a greater extent to achieve a three-dimensional design and two-dimensional design of the uniform, and also greatly improved the efficiency of drawing. KEY WORDS: Fan, Design of injection mould, moldflow analysis 目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc169797365 摘 要 Ⅰ HYPERLINK \l _Toc169797366 Abstract Ⅱ HYPERLINK \l _Toc169797367 1 绪论 PAGEREF _Toc169797367 \h 1 HYPERLINK \l _Toc169797368 1.1 塑料模具技术的发展现状和趋势 PAGEREF _Toc169797368 \h 1 HYPERLINK \l _Toc169797368 1.2 塑料制件的设计原则 2 HYPERLINK \l _Toc169797368 1.3 注射模设计要点 3 HYPERLINK \l _Toc169797377 2 模具设计 4 HYPERLINK \l _Toc169797373 2.1 吹吸机风扇塑件成型工艺性分析 4 HYPERLINK \l _Toc169797384 2.1.1 塑件结构分析 4 HYPERLI