基于DDS和单片机数字控制信号发生器的设计外文翻译中英对照英汉互译.docxVIP

Design of Digital Controlled Signal Generator Based on DDS and MCU Yinjun Chena, Zehuai Yuan Faculty of Electronic Information and Mechanical Electrical Engineering, Zhaoqing Zhaoqing 526061, China Keywords: DDS; MCU; Signal generator; Phase Accumulator; DAC Abstract. Its advantage to use DDS chip is output signal frequency bigger, and precision higher, But users cant change the output signal waveforms. The MCU can produce the required arbitrary waveforms, but its program execution of the order limit the speed.So we use their Synergy to design the digital controlled signal generator. The System has the advantage of output good quality waveform, frequency of precision and stability ,and high frequency, empty, amplitude and phase is to step into the need. Introduction The digitally synthesized sine waveform (Direct Digital Synthesis, DDS) is a well-known method and has been applied to many embedded applications [1]. This technique can be used to create a positive digital sine waveform. Compared to other frequency composing method, Direct Digital Frequency Synthesis(DDS) has been the most popular trend in modern frequency synthetic technique for its excellent characteristics. The signal source that the DDS technology realizes can carry out accurate controlling on DDS frequency , extent , phase exporting wave forms etc. by numerical control circuit, the system making use of this method has many merits such as stability, reliably and accuracy. The commercial DDS chip can only export a sine wave for the data in the ROM form already has been solidified. If needing to come into being any wave form, it may come true by the way that FPGA adopts DDS IP core or hardware describe language etc, however,the cost of This way cost is high; on the other hand, any wave form can be achieved by making use of micro controller unit (MCU) to carry out figure frequency combining and DA converting. The experiment and applying testing have shown that the