化纤废水预处理及混合废水达标处理中试研究-环境工程专业论文.docxVIP

化纤废水预处理及混合废水达标处理中试研究 Study of pilot test on pretreatment of chemical fiber wastewater and treatment for meeting discharge standard of mixed wastewater Abstract The wastewater which was researched in this article came from petroleum chemical fiber enterprise，which located in aromatic hydrocarbon base of LiaoYang petroleum chemical industry park，and domestic sewage from HongWei district．The main kinds of industrial wastewater were polyester wastewater,cutting fluid and cooling liquid wastewater．Petroleum chemical industrial wastewater was difficult to biochemical treatment，it had complex organic pollutant composition，water quality fluctuation，therefore，it required pretreatment，and then mixed witll sewage before biochemical treatment．The main research content was as follows： Firstly，pilot-scale test of industrial astewater pretreatment was carried through using hydrolytic acidification and contact oxidation pretreatment，hydrolytic acidification with special inoculum and contact oxidation pretreatment and catalytic ozonation pretreatment，respectively．Comparing the COD，NH4+-N，TN removal rate and the change of the B／C of three pretreatments，the optimal pretreatment process was put forward．The experimental results indicated that COD removal efficiencies were 44．6％and 63．8％。NH4+-N removal efficiencies were 44％and 54．8％，and TN removal efficiencies were 44．6％and 63．8％．using hydrolytic acidification and contact oxidation pretreatment technology,hydrolytic acidification、加t11 special inoculum and contact oxidation pretreatment，respectively．For catalytic ozonation pretreatment process．COD and NH4+-N removal efficiencies were 63％and 1 6．4％， respectively,meanwhile the B／C ratio was obviously increased．In brief,the higher COD，NH4+-N and TN removals were acquired through hydrolytic acidification with special inoculums and contact oxidation pretreatment；while catalytic ozonation pretreatment process afforded similar COD removal and improved the B／C；but with lowest NH4+-N removal． Sec