基于bim技术的机电管线防碰撞研究-建筑与土木工程专业论文.docxVIP

广东工业大学硕士学位论文AB 广东工业大学硕士学位论文 AB STRACT For the design method of building mechanical and electrical pipelines，the traditional design is easy to master,to facilitate drawings，and has a high efficiency,but compared to 3D collaborative design,the designers of traditional design doesn’t coordinate until the whole system has been designed，it will aslo lead to the following questions：2 D drawings have problems of fuzzy formation,coordination difficulties，limited quantity,and low efficiency；the designers doesnt understand the overall design concept，and cant make the right decision when the electromechanical pipelines collision occurs；．The cause ofthis result is that the design standard is not unified by the designers，the design based on the independent space，the coordination between the way as a single，the designer can not grasp the overall design of rule by the designers and the correlation between the design results，it is thus clear that，the planning work before design is extremely important to reduce the collision of electromechanical pipelines． Due to the waste of design data,new projects repeat previously encountered trouble， therefore the design of the data collection and analysis is a very important work．From the data analysis we can find the law of collision between all design results and recognize the relevance between different professional designs．The visual representation of collision itself is the collision ofobjects and objects，the root ofthe collision is，in fact，the different design concept of collision between the designers． This article embarks from the mechanical and electrical equipment of the professional pipeline collision itself；counted the data of collision between the professional pipeline equipment，and then classified the collision data by using factor analysis method，at the same time,got the correlation between samples of collision index．Factor analysis to dig out call represent the arrangement rule of the collision munbers in different professions