基于fds模拟温度场作用下钢框架性能化抗火研究-结构工程专业论文.docxVIP

武汉理工大学硕士学位论文Generally 武汉理工大学硕士学位论文 Generally speaking，the traditional design of resistance to fire on structure applies IS0834 standard warming up curve as environmental temperature，however, the practice proves that different fire sites have different warming up curves and sometimes there are huge difference．At present，the steel structure design of resistance to fire still utilizes the component design method of resistance to fire based on experiment．nis method has many advantages such aS simpleness．direct-viewing, convenience and SO on，but there are still have SOme shortages．Several years’ practical application shows that the method has a few disadvantages in theory,but the calculation for steel structure limit bearing capacity of resistance to fire can solve this problem well．It is necessary幻develop profound research on the steel structure design method of resistance to fire baSed on calculation under the condition of tree fire situation,and this research can provide important theory Oil resistance to fire and have engineering values．Based on consulting lots of documents，this paper has completed SOme research as follows． 1)According to the design idea of resistance to fire on architectural performance，this paper performs the analysis and computation of fire duration in a certain fire site，at the same time,carries out the analysis of resistance to fire in the duration period． 21皿e fire simulation SOftware(FDS)is used to calculate the practical warm up curve of air when a fire breaks out,and this olive is considered environmental temperature in structural analysis and compared with IS0834 standard warming up curve． 3)Under the case of two sorts of warming up curve，the finite analysis SOftware (ANSYS)is used to compute the temperature distribution ofcomponent section fired． 4)Under the condition of practical warnl up curve，the SOftware(ANSYS)is ufiljzed to analyze the couple of thermal—structure on steel frame structure．11le paper examines the time of resistance to f