基于丝网印刷的亚克力基材烫印质量研究-包装工程.PDFVIP

第38 卷 第 1 期 包 装 工 程 2017 年 1 月 PACKAGING ENGINEERING ·191 · 基于丝网印刷的亚克力基材烫印质量研究 严美芳，李婧，陈景华 （上海理工大学，上海 200093 ） 摘要： 目的 解决亚克力基材烫印工艺中产生的橘皮、裂纹、糊版等质量问题。方法 利用丝网印刷与热 转印相结合的新技术，通过大量的实验及数据分析调整丝网工艺和烫印工艺，确定烫金浆和辅助剂的调 配比例，干燥温度和时间，以及烫金温度。结果 实验结果表明，烫金浆、固化剂和稀释剂的质量比为 10 ∶2.5 ∶1.2 时，烫金效果最好，不会出现亚克力烫金箔的橘皮现象；烫金浆的最佳烘干温度为 80 ℃， 最佳烘干时间为 45 min ，烘干、烫印温度为 130 ～150 ℃时烫金效果最好，不会出现亚克力烫金箔的裂 纹或糊版现象。结论 烫金浆与辅助剂的质量比、烫金浆的干燥温度和干燥时间及烫印温度是决定亚克 力烫金质量的关键因素。 关键词：亚克力；丝网印刷；烫金浆；温度 中图分类号：TS801.4 文献标识码：A 文章编号： 1001-3563(2017)01-0191-04 Quality of Hot Stamping on Acrylic Based on Screen Printing YAN Mei-fang, LI Jing , CHEN Jing-hua (University of Shanghai for Science and Technology, Shanghai 200093, China) ABSTRACT: The work aims to solve such quality problems as peeling, cracking and filling in during the hot stamping process of acrylic substrate. Based on the new technology integrating screen printing and thermal transfer printing, the screen process and stamping process were adjusted, and the mixing proportion of gold stamping pulp and auxiliary agent was determined, the drying temperature and time as well as the temperature of stamping were determined through plenty of experiments and data analyses. The results showed that when the mass ratio of gold stamping pulp, curing agent and diluent was 10 ∶2.5 ∶1.2, the effect of hot stamping was the best and no peeling of hot-stamping acrylic foil would occur. The optimal drying temperature of gold stamping pulp was 80 ℃ and the best drying time was 45 minutes. When the temperature of drying and hot stamping was 1