诺基亚基站开通步骤.docVIP

Introduction to Nokia WCDMA BTS site commissioning 介绍诺基亚WCDMA基站现场调试 Visual checks and inspection视觉检查和视察（检查） First part of the visual check is done before powering on the BTS site at the power system. When all is proven to be OK, the Power on check is done and the LED status is verified. The equipment is checked visually to see that there are no fatal installation errors, which might lead to equipment damage during the power on.第一步。先检查设备的安装情况，看看有没有致命的错误安装，这可能导致的加电过程中对设备造成损害。检查之前完成对BTS设备供电。当一切都正常，LED是检验设备正常运行的关键。 The following items are checked:下列项目检查： the grounding 接地 power cabling and supply voltage电缆和供电电压 other cables and fibres 其他电缆和光纤 LED status during power up 在开机时LED的状态 TX/RX/antenna connector torque check TX / RX /天线连接器扭矩检查 Local SW download（本地软件下载） This step contains all the actions required to update and/or download SW to the equipment or to the PC for managing the equipment at the site. The exact order in the step sequence is equipment specific and thus might take place after some self tests.这一步包含了所有必要的版本更新和/或下载软件到设备，或到电脑上来管理设备。先按照设备的指令，一步一步然后自己完成。 Parameter setup参数设置 This contains all the actions required to set up the parameters for commissioning and for integration. Parameters may include software parameters fed in manually or as a file. 这包含设置参数用于调试和集成所需的所有操作。参数可包括输入的手动参数或作为文件的软件参数 Commissioning tests调试试验 Typical tests and measurements:典型的测试和测量： internal loop tests内部回路测试 external alarm and control tests外部报警及控制测试 site tests SITE测试 site support system alarms shown at the BTS站点支持系统报警会显示在基站 RF max power measurement (optional test)最大射频功率测量（可选测试） Some of the functional tests need more parameters than are available during the commissioning and thus can be run only after the network element has been integrated and it is able to get the rest of the parameters from the RNC.在功能测试部分需要更多的参数，从而可以运行后才可以在网络元素中被集成，这是能够获得来自RNC其余的参数 Troubleshooting疑难解答 The Technical Notes (TN), generic failure reports (GFR) and Change Deliveries (