康宁dc解决方案介绍---郑州.ppt

INTERNAL NOTE: Can’t go into any details about the design. DO NOT disclose it is Fluorine. Additional details are proprietary at this time. 照片显示了标准激光优化跳线和低损耗超强抗弯OM3跳线在带系紧的捆扎带的松环中的影响。该测试用于模拟在重新敷设跳线时，如果松环调节不当以及拉得太紧，将会发生的典型迁移、新增和变更（MAC）事件。使用ClearCurve MMF，就能够杜绝原本可能发生的供电中断现象。 照片显示了标准激光优化跳线和低损耗超强抗弯OM3跳线在带系紧的捆扎带的松环中的影响。 该测试用于模拟在重新敷设跳线时，如果松环调节不当以及拉得太紧，将会发生的典型迁移、新增和变更（MAC）事件。使用ClearCurve MMF，就能够杜绝原本可能发生的供电中断现象。 。 A lot of our testing was done at 2 full turns – which is consistent with the standards-type deployments we’ve been talking about. However – how many of you have seen a cable that was wrapped exactly 2 full turns in an actual deployment? It just doesn’t happen like that. So – in order to better understand how multimode fiber behaves in a real-world deployment – we modeled a typical storage area network link. You don’t need to understand all the details of this picture – it’s purpose is just to show that it is possible to get upwards of 35 ? turns in a typical deployment. There are also a lot of deployments with a smaller number of ? turns so in order to be somewhat representative of the broad range that exists today – we chose to do additional testing at 20 ? turns. We looked at cable options, so now let’s look at 接头options for a Plug PlayTM Systems trunk solution. One option is a high-density MTP style connector, which features 12 fibers in one 接头with push/pull style latching. There is also a low-loss option available. We also have small-form-factor LC and MT-RJ connectors, and of course the 传统的style connectors: SC duplex and ST compatible. The high-density MTP gives you the most value relative到space savings and speed到install. 12 SC style connectors versus one MTP 接头gives you speed of install and density that may be required in your 数据中心. So, plugging in one 接头with 12 fibers versus 12 discrete connectors, you can definitely see the space, cost, and time savings for your 数据中心. 75% faster and easier installation than traditional cabling solutions through MTP?