镁合金表面沉积铜钨复合涂层工艺及涂层性能研究-表面技术.PDFVIP

第44卷摇 第5期 摇 摇 摇 表面技术 摇 摇 2015年05月 SURFACE TECHNOLOGY ·43 · 試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試 镁合金表面沉积铜钨复合涂层工艺及涂层性能研究 贾平平,马捷,王晓光,魏建忠,范爱玲 (北京工业大学,北京 100124) 摘摇 要: 目的摇 提高镁合金表面的耐蚀耐磨性。 方法摇 采用冷喷涂与化学气相沉积(CVD)相结合的方 法在镁合金表面制备出Cu/ W复合涂层,并对复合涂层的结构、成分、组织形貌、耐磨性、耐蚀性、结合力 进行分析。 结果摇 镁合金基体沉积Cu/ W复合涂层后,表面硬度提高了687.1HV,磨损率从0.032%降 到0.020%,腐蚀电位正移了1.3 V,临界载荷相比直接化学气相沉积W 涂层提高了120.5 N。 结论 Cu/ W复合涂层显著提高了镁基体的耐磨、耐蚀性,涂层与基体结合力较高。 关键词:化学气相沉积;冷喷涂;Cu/ W复合涂层;耐磨性;耐蚀性;结合力 中图分类号:TG174.44摇 摇 摇 文献标识码:A摇 摇 摇 文章编号:1001鄄3660(2015)05鄄0043鄄05 DOI:10.16490/ j.cnki.issn.1001鄄3660.2015.05.008 Process Preparation and Properties of Cu/ W Composite Coatings on the Surface of Mg Alloy JIA Ping鄄ping,MA Jie,WANGXiao鄄guang,WEI Jian鄄zhong,FANAi鄄ling (Beijing University of Technology,Beijing 100124,China) ABSTRACT:Objective To improve the corrosion properties and wear resistance of magnesium alloy surface. Methods Cu/ W composite coatingswere prepared successfully on magnesium alloy surface by cold spray and chemical vapor deposition (CVD). The microstructure,chemicalcomponents,morphology,wearresistance,corrosionpropertiesof compositecoatingsandthebinding force of composite coatingswere studied. Results The surface hardness of Cu/ W composite coatings increased by687.1HV com鄄 pared to magnesium alloy matrix,thewear ratefell to0.020% from0.032%,the corrosion potential increased by 1.3 V andthe critical load of compositecoatingsimprovedby 120.5 NcomparedtoWlayerdirectlypreparedby CVD. ConclusionPreparationof Cu/ W composite coatings significantly increasedwear resistance,corrosion properties and greatly improved the coating adhesion. KEY WORDS:CVD;cold spray;Cu/ W composite coatings