基于DSP的水轮机调速器研究-控制理论与控制工程专业论文.docxVIP

AbstractIt Abstract It is known that hydraulic turbine speed governor is one of the important equipment in the hydropower station．It governs the speed，the operating mode and power output of hydraulic turbine．Its performance execs important influence on the quality of electric energy and operational reliability of the hydro power plants．It is an active subject to research software and hardware realization of turbine speed governor． In the paper,first，an overview about the history，current status and trend of hydroturbine governor is discussed．And then the benefits of using DSP are summarized in brief．Referred the fuzzy logic theory and脚LAB．the self-adjusting parameter PID control strategy based on the fuzzy lo酉c is proposed．It makes governor more adaptive to the real conditions．ne simulation result shows PID controller with parameter fuzzy self-adjusting is more available 弧e following two chapters．it first introduces the basic knowledge of TMS320U砣4(h．then the hardware and software design of hydroturbine governor based on TMS320U吃407 developed by the author are dissertated in detail．ne chapter of hardware design first expounds the whole design．Several primary circuit are designed，including frequency measuring circuit，PWM signals output circuit，LCD display circuit,analog signals input circuit，Oil·off input and output circuit and the interface circuit between the DSP and PC． Software design firstly introduces software development environment and the task of software design for DSP based HydraulicTurbine speed governor．Then it gives several key subprogram，including frequency measuring，～D convert， PWM output witll a dead band，LCD display．In addition，a method to program on-chip flash of DSP over the serial communications interface is also presented． At last，the author gives a summary of the whole thesis and points out the shortage of this paper and more research for requirement． Keywords：Hydraulic turbine governor,Fuzzy control，DSP Ⅱ 武汉理工大学硕士学位论文第1章绪论 武汉理工大学硕士学位论文 第1章绪论