阶梯形刃口精密冲裁过程有限元模拟及实验研究-材料加工工程专业论文.docxVIP

燕山大学工学硕士学位论文Abstract 燕山大学工学硕士学位论文 Abstract Fine—blanking traditional process pressed by blank holder with teeth is very complicated，and it need to use expensive triple action presses，that limit its application，SO it is necessary to develop a new and simple process to replace the complicated traditional process．Fine blanking process with tool of stepped edges can make high quality parts by choosing parameters and can be implemented on common press．The cost is lower than traditional process but the research and application in industry of it is hardly visible． In this paper,the main work is to study how parameters that impact the blanking such as the negative clearance，optimum clearance，height and width of stepped edges by using finite element method．Taking experiment on the Q235，coppeL in the condition of positive clearance is O．04 mm and width of stepped edges is 1．2 mm the negative clearance between 30％and 40％of the thickness depend on the finite element method conclusion．The sheet thickness is between 3 mm to 8 mm，and the parts with perfect burnish zone ale made successfully． Result shows when the reasonable parameters matched in optimum clearance is 0．5％-2％of thickness．the negative clearance is 15％-30％of thickness and height of the stepped edges is 20％-30％of thickness the high quality burnish zone section will be achieved，and parts are separated successfully． Keywords Fine-blanking；Negative clearance；Stepped edge；Burnish zone； Finite element method Ⅱ 燕山大学硕士学位论文原创性声明本人郑重声明：此处所提交的硕士学位论文《阶梯形刃口精密冲裁过 燕山大学硕士学位论文原创性声明 本人郑重声明：此处所提交的硕士学位论文《阶梯形刃口精密冲裁过 程有限元模拟及实验研究》，是本人在导师指导下，在燕山大学攻读硕士学 位期间独立进行研究工作所取得的成果。据本人所知，论文中除已注明部 分外不包含他人己发表或撰写过的研究成果。对本文的研究工作做出重要 贡献的个人和集体，均已在文中以明确方式注明。本声明的法律结果将完 全由本人承担。 作者签字铂遵M 日期：砷年s月1％日 燕山大学硕士学位论文使用授权书 《阶梯形刃口精密冲裁过程有限元模拟及实验研究》系本人在燕山大 学攻读硕士学位期间在导师指导下完成的硕士学位论文。本论文的研究成 果归燕山大学所有，本人如需发表将署名燕山大学为第一完成单位及相关 人员。本人完全了解燕山大学关于保存、使用学位论文的规定，同意学校 保留并向有关部门送交论文的复印件和电子版本，允许论文被查阅和借阅。 本人授权燕山大学，可以采用影印、缩印或其他复制手段保存论文，可以 公布论文的全部或部分内容。 保密口，在 年解密后适用本