交通土建毕业设计（论文）-铜汤路第十一标段一级公路设计.doc

全套图纸加扣 3012250582 全套图纸加扣 3012250582 摘要 本设计为安徽省铜陵市到池州市之间K70+0~K73+051.081一级公路的设计，本路段所处地形为平原微丘区，公路自然区划为Ⅳ3区，根据当地的交通量和增长率确定设计时速为80km/h，双向四车道，设计年限为15年，公路全长3051.081m，本设计中主要进行了道路的选线定线、平面、纵断面、横断面、路基、路面、排水、施工组织设计和概预算等。本设计中道路平面上有两个交点，圆曲线半径分别为600m和800m，竖曲线有一个交点，竖曲线半径为5000m，在此基础上进行了平曲线超高、路基设计、路面各层厚度计算，在高填深挖地段进行边坡稳定性验算，以及路基路面的排水和水力验算，所设计工程的施工组织设计概预算等，最终完成本次设计。 关键词：一级公路；选线；施工组织设计；概预算；验算 Abstrac The design, Tongling City, Anhui Province to the design of K70+0~K73+051.081 highway between Chizhou City, the road terrain in plain and hilly area, natural zoning for highway IV zone 3, according to the local traffic volume and growth rate to determine the design speed of 80km / h, two-way four lane, the design life for 15 years, road length 3051.081m. This design mainly for the road line selection line, plane, vertical section, cross section, subgrade, pavement, drainage, construction organization design and budget, This design in road plane has two intersections, circular curve radius 600m, 800m, respectively, the vertical curve has a point of intersection, radius of vertical curve for the 5000m, on this basis, were flat curve superelevation, roadbed design, pavement thickness of each layer calculation, in high filling digging area for checking the stability of the slope and finalize the design. Key words: First grade highway；Route；Construction organization design；Concept；Estimate 目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc421632898 前言 PAGEREF _Toc421632898 \h 1 HYPERLINK \l _Toc421632899 1 设计原始资料及选线与定线 PAGEREF _Toc421632899 \h 2 HYPERLINK \l _Toc421632900 1.1 设计原始资料 PAGEREF _Toc421632900 \h 2 HYPERLINK \l _Toc421632901 1.1.1自然条件 PAGEREF _Toc421632901 \h 2 HYPERLINK \l _Toc421632902 1.1.2 路线周边状况 PAGEREF _Toc421632902 \h 2 HYPERLINK \l _Toc421632903 1.1.3公路路线的拟定 PAGEREF _Toc421632903 \h 2 HYPERLINK \l _Toc421632904 1.1.4公路设计基本参数 PAGEREF _Toc421632904 \h 2 HYPERLINK \l _Toc421632905 1.2 选线 PAGEREF _Toc421632905 \h 4 HYPERLINK \l _Toc421632906 1.3 方案拟定与比选 PAGEREF _To