毕业设计-二氧化钛电极的化学修饰研究.docVIP

- PAGE I - 本科毕业设计 （20 届） 二氧化钛电极的化学修饰研究 所在学院 专业班级 物理学 学生姓名 学号 指导教师 职称 完成日期 年 月 PAGE I 摘　要 【摘要】使用P25浆料，用刮涂法制备TiO2薄膜光阳极。采用两种方法对光阳极进行修饰：1. 使用二氧化钛溶胶，以旋转涂膜法在导电玻璃上制备致密阻挡层薄膜;2. 以TiCl4溶液处理二氧化钛薄膜。并利用这些电极，制备组装成染料敏化太阳能电池，研究了两种修饰方法对电池性能的影响。发现，经过旋转涂膜法在导电玻璃上制备致密阻挡层薄膜对光阳极修饰以及TiCl4溶液处理二氧化钛薄膜之后电池的开路电压，短路电流及光电转换效率都得到了提高。在旋涂六层致密阻挡层及使用0.4mol/L浓度的TiCl4处理之后的时候各项数据的达到最大值。最高光电转换效率 达到了5.67%。 【关键词】染料敏化太阳能电池；TiO2薄膜电极；旋转涂膜法；四氯化钛处理；DSSC性能 Abstract 【ABSTRACT】Using the P25 slurry, with the Scratch TiO2 Films is prepared by the anode. Two methods used to decorate the anode of light: 1. Using titanium dioxide sol, with spin coating method on conductive glass compact barrier film preparation; 2. TiCl4 solution treated titanium dioxide film. And by the use of these electrodes, prepared and assembled dye-sensitized solar cells, studied the influence of two modification methods on the battery function. Found that, after the spin coating method in the preparation of conductive glass anode compact barrier film for light modification, and battery open circuit voltage, short circuit current, and photoelectric conversion efficiency are increased after TiCl4 solution treatment to titanium dioxide thin film. After Spin density in the barrier layer and the use of six 0.4mol / L concentration of TiCl4 treatment, the data arrives at the maximum time. The highest photoelectric conversion efficiency reaches 5.67%. 【KEYWORDS】Dye sensitization solar cell; TiO2 films; Spin coating method; TiCl4; DSSC performance 目　录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc293308339 二氧化钛电极的化学修饰研究 PAGEREF _Toc293308339 \h II HYPERLINK \l _Toc293308340 摘　要 PAGEREF _Toc293308340 \h II HYPERLINK \l _Toc293308341 Abstract PAGEREF _Toc293308341 \h III HYPERLINK \l _Toc293308342 目　录 PAGEREF _Toc293308342 \h IV HYPERLINK \l _Toc293308343 1 引言 PAGEREF _Toc293308343 \h 1 HYPERLINK \l _Toc293308344 1.1当今社会能源现状：