基桩高应变检测波形拟合法的理论研究与应用-地质工程专业论文.docxVIP

Study and Application of Signal Matching Method for High Strain Dynamic Testing of Pile ABSTRACT High strain dynamic testing method has been widely applied, along with high-speed development of pile foundation engineering. The traveling wave theory and the theoretical knowledge of high strain dynamic testing are described in this paper. The dynamic model of pile-soil system is established on the basis of high strain CAPWAP C matching procedure, and a corresponding MATLAB matching calculation is compiled. Multiple high strain test data, which are collected from different types and sizes of piles in engineering field, are imported in the MATLAB calculation program. The ultimate bearing capacity of pile is quantitative evaluated by the calculation results. Static load test is also did on these piles at the same time. The dynamic model of pile-soil system and MATLAB matching calculation are proved to be correct and reasonable by comparing with the static load test data. Several high strain curves from different piles are calculated by the calculation procedure, it shows that the deviations of the calculation are not identical on different types and sizes of piles by contrast analysis. The precision problem of bearing capacity calculating by the matching calculation in this paper is discussed. The bearing capacity of the piles in engineering field is calculated by using high strain Case pile bearing capacity formula, and the results have been compared with the data of signal matching program and static load test. The influence of Case damping coefficient value on the pile bearing capacity result is analyzed. The distribution graph of the soil resistance around pile is drawn, and the distribution law and the pile bearing capacity influence charact er of the soil resistance around the pile are comprehended intuitively; the graph of the upward traveling wave and the downward traveling wave across the pile section reveals the propagation