夹具控制系统设计与实现-电子与通信工程专业论文.docxVIP

IV IV Abstract The Design Implementation ofFixture Control System inspection on the existence of the products to be tested, the location of the cylinder position to be advanced and the advancement of the cylinder position on the fixture, which simplifies the structure of the hardware of the system. As for the software of the system, it adopts C and assembly language to compile software and use uVision4 written by Keil Software to the compilation. The problems can be solved by this issue are listed as follows: To control the actions of the cylinder by combining the MCU and the electromagnetic valve. E.g. using the cylinder on the fixture controlled by the electromagnetic valve to lock and unlock the products to be tested in the process of testing, and also using the cylinder on general station to forward and backward the fixture. Besides, to do a real-time inspection on the location of cylinders by using sensors not only saves the hardware equipment, improves the stability and reliability of the system, but also simplifies the program of the MCU. Illustrate and analyze the basic requirements in practical application. Firstly, the software design flowchart of the control system should be provided according to the practical testing when designs. Secondly, the software of each function module should be concreted and modularized. Finally, the software control program of the entire fixture control system can be integrated on the basis of the software control program that is specifically compiled. In the process of the software hardware design, the new system takes reliability and stability fully into account, and also extensibility of the function is taken into consideration. Inspection and operation of the fixture control system indicates that the new system can control the car electronics in the testing process by automation, and can improve the efficiency of the products testing. In this way, the quality of the car electronics is guaranteed and the production efficie