梁式转换层的框支剪力墙动力分析及有关抗震问题探讨-结构工程专业论文.docx

PAGE PAGE IV III III ABSTRACT with the city urbanization, land costs rising, and the high-rise buildings increasing, many tall buildings of the city commercial district often require the buildings larger space used as restaurants, shopping malls, and the upper part is often used as offices or residences. Due to the different functional requirements, these buildings offen need to convert structural style. When the upper is the shear wall structure, and the lower frame is supported by frame pillar, the upper load is transferde to the lower frame pillar by the transfer beam, this conversion form is called frame supported conversion. Because the girder transfer layer has been used widely due to the force transmission direct, clear, and easy to calculate,so this paper pays attention to analysy the trailing wall girder transfer floor frame supported shear wall structure. The frame pillar and beam supported frame of the Girder Transfer floor Shear-Wall Structure with Supporting Frames at the bottom will generally use reinforced concrete material, but their strength is lower, the load of the upper part of the shear wall will cause frame pillar and beam supported frame of the bottom to become biger to impact architectural function, and their ductility, aseismic weak ability is poor. For the steel reinforced concrete member with higher bearing strength, better ductility and aseismic capability , the steel reinforced concrete is introduced into the beam supported frame and frame pillar, which can improve the seismic performance of the overall structure In this paper a analytical model is firstly created. Select rightly the section of RC beam supported frame, RC frame pillar, and the section and the steel Specification sizes of SRC beam supported frame, SRC frame pillar by the PKPM calculation results. By comparing it can apparently find the section size of SRC beam supported frame and SRC frame pillar become smaller. At the same time, analyse their influences on structural