经过多天的调试终于调通了,为了方便大家少走弯路,带.docVIP

经过多天的调试，终于调通了，为了方便大家少走弯路，带来痛苦，提高效率，下面将我的感受和源程序写出来，供大家学习！！希望大家共同交流！这个我已经运行了，通过了，大家做的时候先用matlab验证一下sin的频率！然后看计算结果对不！2005.04.7号上午八点40程序纪录，这个程序运算完全正确，和前一个程序不同之处在sin值得大小，由于2812时定点运算，sin值得大小不能太小！否则计算结果为零！2812的fft的错误在于fft.init1(),fft.init2()这两个函数没有这函数库里面定义，而是该用fft.init(fft),而且由于是定点运算，输入的sin值不能太小，要不然计算结果为零！#include DSP281x_Device.h // DSP281x Headerfile Include File#include DSP281x_Examples.h // DSP281x Examples Include File#include fft.h#include #define BUF_SIZE 128#pragma DATA_SECTION(ipcb, FFTipcb);#pragma DATA_SECTION(mag, FFTmag);// Prototype statements for functions found within this file.// Global variables used in this example:Uint16 LoopCount;Uint16 ConversionCount;Uint16 fftflag=0;//FFT转换启动标志:0不启动；1:启动Uint16 i;long Voltage1[BUF_SIZE];long Voltage2[BUF_SIZE];long ipcb[BUF_SIZE];RFFT32 fft=RFFT32_128P_DEFAULTS;//CFFT32 fft=CFFT32_128P_DEFAULTS;long mag[BUF_SIZE/2+1];const long win[BUF_SIZE/2]=HANNING128;int x1;long k=0;double j=0.12345;main(){Uint16 i;// Step 1. Initialize System Control:// PLL, WatchDog, enable Peripheral Clocks// This example function is found in the DSP281x_SysCtrl.c file.InitSysCtrl();// For this example, set HSPCLK to SYSCLKOUT / 6 (25Mhz assuming 150Mhz SYSCLKOUT)EALLOW;SysCtrlRegs.HISPCP.all = 0x3; // HSPCLK = SYSCLKOUT/6EDIS;// Step 2. Initialize GPIO: // This example function is found in the DSP281x_Gpio.c file and// illustrates how to set the GPIO to its default state.// InitGpio(); // Skipped for this example // Step 3. Clear all interrupts and initialize PIE vector table:// Disable CPU interrupts DINT;// Initialize the PIE control registers to their default state.// The default state is all PIE interrupts disabled and flags// are cleared. // This function is found in the DSP281x_PieCtrl.c file.InitPieCtrl();// Disable CPU interrupts and clear all CPU interrupt flags:IER = 0x0000;IFR = 0x0000;// Initialize the PIE vector table with pointers to the shell Interrupt // Service Routines (