ECN依照回流焊炉焊接纯度要求设定为2000PPM.ppt

李伯堅 Jones Lee +8613706209938 勤耀科技股份有限公司 GPCTEK Co., Ltd. (Taiwan) www.gpctek.tw 專業氣體及自動化設備製造商 Automation Equipment Manufacturer Group GPCTEK Co., Ltd. 勤耀科技股份有限公司 群茂機電設備有限公司 ECN2 閉迴路專利氮氣節能裝置(含氮氣分析儀) Closed loop Nitrogen saving devices 勤耀科技股份有限公司 李伯堅 Jones Lee ECN2Function Description: 迴流焊爐專用氮氣節能裝置： Special Designed for Relfow Nitrogen saving devices 可以安裝在任何的氮氣迴流焊爐上. Can be install on any kind of Reflow / Oven. 具備實時偵測迴流焊爐的含氧量. Real time check Oxygen content inside of the Reflow Oven. 設定迴流焊爐內需要的含氧量,自動調節到您要求的純度.控制流量以達到節省氮氣使用量. Setting reflow Oxygen content, The device will Auto-Control the flow rate to achieve the saving Nitrogen. 依照客戶實際測試的數據,可以節省15~50%的氮氣使用量. According to the existing user real data, Can be saving the 15~50% Nitrogen usage amount. ECN2 設計概要 Design concept : 1.目前所有的充氮迴流焊爐,在使用氮氣充氮進行焊接時, 爐膛內的氮氣純度,是依照手動閥門來調整爐膛內的氮氣純度. Most of nitrogen reflow are use the manual valve to adjust the nitrogen purity when filling nitrogen during welding. 2.舉例:如果迴流焊爐焊接要求純度為2000PPM, 但是在沒有節制的情況下,氮氣會一直充入,即使爐膛內的氮氣純度已經到達500PPM 時, 還是一直充入, 一直浪費. For example: if the reflow request the Oxygen purity around 2000 PPM, but in the absence of restraint, filling the nitrogen, nitrogen purity even the reflow chamber has reached 500 PPM. but manual valve still continue filling. That have been wasted. 3. 所以ECN2 就可以杜绝这样的浪费，进而达到节能的目的。 So the ECN2 can put an end to such a waste, and then achieve the goal of energy saving. Device Size：(L:370*W:300*H:450mm)/ 220VAC 如果回流焊炉焊接时纯度要求为2000PPM.但是氮气直接充到回流焊炉时,纯度已经达到500PPM.明显的浪费了很多液态氮,也是很多钱. If inside of reflow are requested the Oxygen purity at 2000 PPM.But the nitrogen charge directly to the reflow oven, even purity has reached 500 PPM.Obviously wasted a lot of liquid nitrogen, is also a lot of money. N2 液態氮 30m3/hr liquid nitrogen 30m3/hr Reflow Requested 2000PPM The purity inside of reflow already reached 500PPM However, nitrogen still continue filling. ECN2 Nitrogen saving devices GPCTEK- ECN2 -依照回流焊炉焊接纯度要求设定为2000PPM.