LTE系统全网信令流程.ppt

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * GAP测量配置流程 GAP Measurement procedure: 1. Ue Send MeasmentReport to eNodeb to indicate A2 event trigged 2. eNodeB Judge the serving cells signal becomes bad and need to trige Inter-Freq or Inter-Rat Measment (there should be Inter-Freq Info or Inter-Rat Freq Info of the serving cell) 3. eNodeB send RRCConnectionReconfiguration to UE, which contain the Gap config and A4 or B1 Measment config 4. UE send RRCConnectionReconfiguration Complete to eNodeB, which means Gap config and A4 or B1 measment config is success Reference: 36.331: Evolved Universal Terrestrial Radio Access (E-UTRA); Radio Resource Control (RRC); Protocol specification, Measurement gap configuration * ANR测量配置流程 ANR Measurement procedure: 1. Ue Send MeasmentReport to eNodeB to indicate A3 or A4 event trigged, and strongest PCI is unknown(eg. the PCI belongs to another eNodeb) 2. eNodeB send a new Measment to command UE to report the CGI of the unknown PCI, and a long DRX cycle may be needed for UE to read the NCELLs SYSINFO 3. UE reads the NCELLs SIB1 to get the NCELLs CGI and reports it to eNodeb 4. SRC eNodeb send RRCConnectionReconfiguration which contains HO command to UE 5. UE random access to the Tar eNodeb 6. Tar eNodeb may send new Measment require to stop the old CGI measment Reference: 36.331: Evolved Universal Terrestrial Radio Access (E-UTRA); Radio Resource Control (RRC); Protocol specification, 5.5.4 Measurement report triggering * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * UE上下文释放流程（续） The MME initiated detach procedure is either explicit (e.g. by OM intervention) or implicit. The MME may implicitly detach a UE, if it has not had communication with UE for a long period of time. The MME does not send the Detach Request (Detach Type) message to the UE for implicit detach. The implicit detach is local to the MME, i.e. an SGSN registration will not be detached. If the UE is in ECM-CONNNECTED state the MME