贵州关堰大桥施工组织设计.docVIP

河北工程大学土木工程学院毕业设计说明书 2010年 PAGE 43 毕业设计说明书 贵州关堰大桥施工组织设计 专 业：土木工程(道桥方向) 姓 名：李金垣 指导教师：马健生 河北工程大学土木工程学院 摘要 本桥于关堰村北边缘穿过，平面位于R=2050m左偏的圆曲线上，在K2+246.0处跨越乡村道路，该路宽3.6m，斜交角度130度，砂石路面。在K2+367.0处跨越鱼梁河，河道顶宽11.0m，底宽8.4m，深2.5m，河岸为片石码砌，河底基岩外露，与路线基本正交。桥梁布设时考虑正交跨越鱼梁河，河道置于跨径中部，桥梁全长为459.7m。 桥梁布孔以路线中心线处为标准跨径，桥梁墩台在平面均按径向布置，即各桥墩墩帽中心线和桥台台帽背墙前缘线与路线中心线交点处的切线成相同角度。由于曲线影响，同一孔内预制T梁均不等长，采用调整预制梁长的方法进行设计，在连续处墩顶现浇横梁宽度仍然与通用图一致。梁长调整设在预制T梁端部的直腹板段，便于施工。由于曲线影响，预制T梁的边梁悬臂按曲线变化。桥面总体横坡由墩台盖梁形成，相邻两片梁间预制横坡和桥面横坡通过梁顶调平层调整。 关键词：预应力混凝土T形梁 钻孔灌注桩 桥梁 施工组织设计 Abstract The Bridge on the north edge of the relevant Yancun through the plane at R = 2050m left side of the circular curve, cross the rural road at the K2 +246.0, the lane is 3.6m, oblique angle of 130 degrees, gravel road. cross Yuliang River at the K2 +367.0, channel top width of 11.0m, bottom width 8.4m, depth 2.5m, the stone yards of the river for the piece puzzle, the bottom of the river exposed bedrock, and the basic orthogonal lines. Laid across the bridge to consider the orthogonal Yuliang, channel span put the middle of the bridge，the length of the bridge is 459.7m. The Hole of bridge to the center line of the standard line span, the bridge pier in the plane Junan radial arrangement, namely, the centerline of Pier cap and bridge abutment cap front line and the line of the back wall of the center line into the intersection of the tangent the same angle. As the curve of the same hole pre-T beams are not of equal length, by adjusting the length of the method of precast beam design, cast in a continuous beam width of the pier top office is still consistent with the general plan. Beam length adjustment in pre-T beam web end of the straight section, to facilitate construction. As the curve of the impact of pre-T cantilever beam by beam edge curve. Overall bridge pier cap beam cross slope formed by the adjacent two prefabricated beam cross slope and cross slope by beam roof deck leveling adjustment layer. Keywords: Prestressed concrete T