许辉明冷却器培训.pptVIP

* 液压驱动翻板式排料机构 SWIVEL VALVE DISCHARGE GATE 运行前的调整 Adjustable before Operation 限位开关 (Proximity Switch) 与触头 (Plexiglas) 的间隙在 1 mm 以内 Space between Proximity Switch and Plexiglas must be less than 1 mm. 限位开关的感应部分离开传杆 2 mm The sensing part of proximity switch is 2 mm off from the stick(3) 在关闭位置 : 相邻的两个翻板之间的 间隙大约 是所生产颗粒料直径的三倍 Close Position: Put “Close” switch on approximately 3x product diameter (d) (A = 3d, A is about 10 mm.) * 冷却器额定排料量调整 Adjustable Product Discharge Capacity from Cooler 通过调整额定排料量至与额定进料量相匹配，就能使颗粒料层在冷却器里得到稳定，造成流经颗粒料层的空气能规则流动，从而可使冷却均匀。 By adjust discharge capacity in proportion with intake capacity this will stabilize the product layer in cooler. So the air pass through the product layer is regular flow, this will even the cooling process 顺时针方向转动手轮，使下部框向左移动至与中间框具有较小的间隙，可以减小额定排料量。 相反地，逆时针方向转动手轮，使下部框向左移动至与中间框具有较大的间隙，可以提高冷却器额定排料量。 By turn the handwheel clockwise, this will move the lower grid through the left cause less gap in proportion with the middle grid and discharge capacity are decreased. On the contrary by turn the handwheel anticlockwise, this will move the lower grid through the right cause more gap in proportion with the middle grid and discharge capacity are increased 滑动式排料 / SLIDE GRID DISCHARGE * 通过移动 “打开传感器” (1) 离开“关闭传感器” (2)，可以提高冷却器 额定排料量。 By move “Open Sensor” (1) far away from “Close Sensor” (2) this will increase discharge capacity from cooler. 翻板式排料 / SWIVAL VALVE DISCHARGE 1 2 通过调整额定排料量至与额定进料量相匹配，就能使颗粒料层在冷却器里得到稳定，造成流经颗粒料层的空气能规则流动，从而可使冷却均匀。 By adjust discharge capacity in proportion with intake capacity this will stabilize the product layer in cooler. So the air pass through the product layer is regular flow, this will even the cooling process. 冷却器额定排料量调整 Adjustable Product Discharge Capacity from Cooler * 气流速度调节 Adjustable Air Flow Rate 靠与控制电机电流设定值比较，采用“空气流动控制阀”来 控制风闸，以调节通过颗粒料层空气的气流速度。 “AIR FLOW CONTROL VALVE” controls the damper by compare motor current with set point