体验新一代测量与测试仪器提升信号测量与电路分析水平.ppt

DPO4000 系列数字荧光示波器串行触发和分析 仅仅解码是不够的…还要 触发分组级内容 搜索和标记分组级内容 事件表 I2C CAN SPI I2C译码总结 DPO4000 强大的I2C 触发还包括许多其它功能： Start - 在SDA 变低、SCL 为高时触发。 Repeated Start - 在没有上一个停止条件下发生开始条件时触发。这通常是主设备发送多条消息、而没有释放总线时发生的情况。 Stop - SDA 为高、SCL 为高时触发。 Missing Ack - 从设备通常配置成在每个地址和数据字节后发送确认。在从设备没有生成确认位的情况下示波器可以触发采集。 Address - 触发用户指定的地址或任何预先编程的专用地址，包括全呼、开始字节、HS模式、EEPROM或CBUS。地址可以是7 位或10 位地址，以二进制或十六进制输入。 数据 - 触发二进制或十六进制输入的最多12 字节的用户指定数据值 地址和数据 - 可以输入地址数据值及读写，捕获确切的感兴趣的事件 这些触发可以隔离您感兴趣的特定总线业务，解码功能则可以即时查看采集中总线上传输的每条消息的内容。 竞赛CANBUS译码 – 找到地址为 * Let us look at switching voltages and current characteristics for a active PFC SMPS. To maintain steady output voltage and power, with varying line voltage and line current to follow the line voltage, gate drive signal is Pulse width modulated. The variation is such that, while input voltage is maximum the duty cycle is at minimum and line voltage is at zero the duty cycle is at maximum. This causes the conduction time to vary and in some design SMPS to switch between DCM to CCM vise versa. To make accurate measurement in this scenario complete half cycle duration, information needs to be captured. For eg. 50Hz, we need to capture atleast 10msec duration info. * Just capturing long duration information is insufficient for accurate measurement, other important attribute is sample resolution. For an accurate characterization of any transition it is recommended to have 5 samples/ edge for accurate switching loss measurement. Accuracy of a switching loss measurement is depends upon the number of samples per edge. You can also note that higher the recording time also demands longer record length with enough sample resolution.. * For easy and quick analysis, it advisable to capture the one full cycle of the line frequency. For e.g. to capture 20msec(50Hz) duration line signal with PWM signal with a rise time of 100 nsec demands for 1.6 MB record length. Today you get this performance on Tektronix TDS5000 series oscilloscopes. This scope provide 2MB record