材料与试验协会 B114-90（2001）分流器与精密电阻器用薄板材料的温度-电阻常数的测试方法.PDFVIP

Designation: B 114 – 90 (Reapproved 2001) Standard Test Method for Temperature-Resistance Constants of Sheet Materials for Shunts and Precision Resistors1 This standard is issued under the fixed designation B 114; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon () indicates an editorial change since the last revision or reapproval. 1. Scope in such a manner that there will be no change of current 1.1 This test method covers the determination of the change distribution in the specimen during the test. of resistance with temperature of sheet materials used for 5.2 Potential terminals, one at each end, shall be located at shunts and precision resistors for electrical apparatus. It is a distance not less than two times the width of the specimen applicable to materials normally used in the temperature range from the current terminals. These terminals shall be attached at of from 0 to 80°C. the center of the width of the specimen either by soldering to 1.2 The values stated in inch-pound units are to be regarded ears cut out of the specimen (Note 2) as shown in Fig. 1 or by as the standard. The metric equivalents of inch-pound units clamps, each of which presses a single sharp point into the may be approximate. material. 1.3 This standard does not purport to address all o