照排机常见报错信息以及问题基本判断.docVIP

照排机常见报错信息以及问题基本判断 Error number: ERR_0002 Error type: ERROR Internal error An error occurred in the program sequence -- Note down the error number and inform the service department Check the modification notes of the current software and hardware --未连上冲版机 Error number: ERR_0014 Error type: ERROR An error occurred in the mirror motor unit The time monitor reports timeout during the spin-up phase of the mirror motor -- The recorder hardware is defective. Note down the error number and inform the service department Check the mirror motor unit --出片有波浪形状的变形，转镜SOL板有问题 Error number: ERR_0016 Error type: CRITICAL ERROR An error occurred in the air supply unit The air safety switch is not closed -- Switch off the recorder and restart it. If the error still occurs, note down the error number and notify the service department Check the air supply unit --气压不够，漏气 （1）将肥皂水涂在气管接口处，有气泡出现则为漏气的地方 （2）将顺时针转，如机器不能启动，将的气管插在一个带调节阀的气压表上，如果机器能起来，则要清洁或更换气压调节阀 （3）将排水电磁阀处气管用手堵上，如果机器能起来则排水电磁阀有问题 （4）用气压表量压缩泵出来的气压，应该瞬间达到0.4MPa，如果瞬间气压太小则要清洁或更换压缩泵 Error number: ERR_0017 Error type: ERROR An error occurred in the air supply unit The mirror air cooler temperature is to high -- Switch off the recorder and restart it. If the error still occurs, note down the error number and notify the service department Check the air supply unit --制冷有问题 （1）量X71插头上是否有直流14伏电，如没有则MASC问题 （2）如有电，用手摸制冷片外面铜块，如铜块不凉，则制冷片问题 （3）如上述两点都没问题，在超级终端看制冷温度，如果温度不对，则传感器问题 Error number: ERR_0019 Error type: CRITICAL ERROR An error occurred in the air supply unit The air pump did not start TimeOut while reading vacuum pump sensor on fpga-port. Switch off the recorder and restart it. If the error still occurs, note down the error number and notify the service department Check the air supply unit --主板，MASC，MAIR，真空泵 Error number: ERR_0020 Error type: ERROR An error occurred in the optic unit The focus stepping motor cannot find the zero position -- The recorder hardware is defective. Note down the error number and inform the service department C