可行性分析例图.ppt

PART NAME:D0CW-FRT-DWO52017-K-01_plastic Red area exceed the 4°for texture ,yellow area was less than 红色蚀纹区域超过4度方便晒纹，黄色区域不够4度 Suggest to modify this hole and let the green area coring from the cavity side.建议更改这个孔使绿色区域从前模出. yellow area and the 2 holes around was less than 4°红色区域和两个孔周围不足4度 2.5 2.6 2.5 Rib-to-wall with the same thickness Easily to be sinked.骨位跟产品壁厚几乎相同容易产生缩痕 2.5 2.75 It’s easily to be sinked , we recommend to remove some material这里很容易产生缩痕，建议移除一些胶料会好些 The existed parting line was red one, the cavity side is to sharp, please change the part design to move the parting line to the blue line area.红色线显示的是现有的分型线，前模面太尖锐，建议更改产品分型线到蓝色线位置. 后模面R太尖锐我们建议取消R. The rib was undercut, we suggest cancel the rib这条肋骨是倒扣，建议取消 Too many undercuts, we suggest to change the part structure along the parting line.太多倒扣，我们建议沿些此分型线更改产品设计. 分型线 前模 后模 These 2 holes will form by lifter, but there would be interference with the red rib when the lifter moving,please cancel the red rib.这两个孔需要做斜顶，但斜顶移动时会于红色骨位冲突，建议取消红色骨位. Lifter Lifter The 7 lifters travel clearance was enough.这里7个斜顶的移动空间是充足的. 3.0 Need to make lifter here, the steel is to thin then.这里需要做一个斜顶，那么这两个 斜顶之间的钢料就太薄了. When demoulding, The side rib would be sticking to the lifter, It’s hard to run it automatically.脱模时里面骨位会粘到斜顶上，很难全自动生产. lifter Lifter Lifter The 2 lifters’ travel clearance is not adequate and the lifters would be very thin.这两个斜顶移动空间不足并且斜顶太薄. before after Lifter Lifter The 2 existing holes were sloped, please change to horizontal, the related assembly also need to be modified accordingly.现有的这两个孔是倾斜的,请改成水平方向，相关的装配也需要据此更改. Option 1 方案2 修改前 修改后 修改前 修改后 If this way,we could cancel the lifter. 如果像这样，我们可以减少一个斜顶。