连杆强度校核.docxVIP

重庆理工大学毕业设计（论文） 文 献 翻 译 学 院 车辆工程 学院 班 级 13461 学生姓名 甘金科 学 号 11304060123 2005-01-0987 SAE系列论文 关于连杆质量和成本降低的优化 ——Pravardhan S. Shenoy and Ali Fatemi The University of Toledo 转载自：钢板材和棒材产品加工创新 (SP-1951) 2005 SAE世界大会 底特律、密歇根四月11-14日，2005 PA 15096-0001美国电话：（724）776-4841传真：（724）776-5760网站： The Engineering Meetings Board has approved this paper for publication. It has successfully completed SAE’s peer review process under the supervision of the session organizer. This process requires a minimum of three (3) reviews by industry experts. All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SAE. For permission and licensing requests contact: SAE Permissions 400 Commonwealth Drive Warrendale, PA 15096-0001-USA Email: \h permissions@ Tel: 724-772-4028 Fax: 724-772-4891 For multiple print copies contact: SAE Customer Service Tel: 877-606-7323 (inside USA and Canada) Tel: 724-776-4970 (outside USA) Fax: 724-776-1615 Email: \h CustomerService@ ISSN 0148-7191 Copyright ? 2005 SAE International Positions and opinions advanced in this paper are those of the author(s) and not necessarily those of SAE. The author is solely responsible for the content of the paper. A process is available by which discussions will be printed with the paper if it is published in SAE Transactions. Persons wishing to submit papers to be considered for presentation or publication by SAE should send the manuscript o