抽油烟机培训资料(ppt 43页).pptVIP

a) A Class 2 circuit; b) A limited voltage/current circuit; c) A limited energy circuit; or d) A limiting impedance circuit. Clause 25 关于次级线路 PCB 板材料本身应符合UL796,且满足要求的厚度要求. 直接支撑PCB 且碰到带电体的绝缘部件应符合UL94的V-0, V-1, V-2. Clause 26 电子线路板 (PCB) 下列元件之外的情况,需要做元件短路测试: 符合二次线路的情况的元件 符合UL991的固态保护元件,如继电器, 空气开关等; 低压风扇中的元气件等. Clause 27 电子元气件 抽油烟机必须接地. 如果带有插头和电源线,必须三芯接地插头. Clause 28 接地 25.1.1 A secondary circuit shall comply with the requirements for one of the following types of secondary circuits: 其中变压器部分，需符合UL1585标准要求的绝缘． Clause 25 Secondary Circuits 变压器的要求 1) 灯应符合UL1598的要求. Clause 26 Printed-Wiring Boards 灯的要求 过滤网必须符合UL 900标准的class 1或class 2. Clause 29 过滤网 １）外壳边缘不应有毛刺和锐边，防滑伤人． Clause 28 Grounding 其他结构问题 Leakage Current Test (泄露电流测试) 测试可接触表面和带电体之间的漏电流 ※ part 2 测试部份 泄露电流测试 33. Continuity of Grounding Circuit Test （接地电阻测试） 测试接地金属外壳的接地电阻，不能大于0.1欧姆 ※ part 2 测试部份 接地电阻测试 基于标准UL5072003版 抽油烟机培训教材  触电危险; 防火危险 过热危险 机械危险 爆炸危险 辐射危险 其他危险 ※ part 1 结构评估 UL安全认证考虑的因素 CONSTRUCTION 6 Frame and Enclosures 6.1 General 6.1.1 An appliance shall be formed and assembled so that it has the strength and rigidity necessary to resist the abuses to which it is subjected, without causing a risk of fire, electrical shock, or injury to persons due to total or partial collapse with a resulting reduction of spacings, loosening or displacement of parts, or other serious defects. 6.1.2 A cast- or sheet-metal section of the enclosure shall not be thinner than the applicable value specified in Table 6.1. Exception No. 1: A small area or surface that is curved or otherwise reinforced to provide equivalent mechanical strength is not required to comply with the specifications in the first column of thicknesses in Table 6.1. Exception No. 2: A section of the enclosure made of uncoated or galvanized sheet steel or cast malleable iron shall not be thinner than the specifications in the first column of thicknesses in Table 6.1 unless such factors as the following are deter