探究水泥混凝土路面应力吸收层的施工技术.docVIP

探究水泥混凝土路面应力吸收层的施工技术 论文摘要:设置应力吸收层的水泥混凝土路面结构型式，对提高水泥混凝土路面的使用品质、改善路面的工作状况、延长使用寿命、减少养护工作量和养护费用、降低水泥混凝土路面全寿命费用具有重要意义，因此，本文开展水泥混凝土路面合理结构形式的研究是十分必要和及时的，有利于水泥混凝土路面的广泛使用。 【 pick to 】 paper setting stress absorbing layer of cement concrete pavement structure, to improve the use of cement concrete pavement quality, improve the working condition of pavement and prolong service life, reduce maintenance workload and maintenance costs, lower the cement concrete pavement life-cycle costs is important, therefore, this paper carried out reasonable cement concrete pavement structure in the form of study is very necessary and timely, is beneficial to the wide application of cement concrete pavement. 　　0 引言 0 the introduction 　　应力吸收层设置于半刚性基层和水泥混凝土路面板之间，一般来说起应力吸收、隔离、防水和封水以及防止反射裂缝等作用。水泥混凝土路面板和半刚性基层之间设置的应力吸收层，具有集料细、矿粉用量大、油石比大、空隙率小、饱和度大等特点，因此，一般采用砂粒式或细粒式的密级配沥青混合料，本文记为YF型。 Stress absorbing layer is set between semi-rigid base and cement concrete pavement plate, generally stress absorption, isolation, waterproof and sealing water and preventing reflection cracks, and so on. Cement concrete pavement plate between semi-rigid base and set the stress absorbing layer, has a large dosage of fine aggregate and mineral powder, oil stone ratio big, small porosity, saturation etc, therefore, generally used for sand or fine particle type dense gradation asphalt mixture, this article notes for YF type. 　　1 施工准备 1 construction preparation 　　1.1 铺筑应力吸收层前，应检查基层的质量，不符合要求的不得铺筑应力吸收层 1.1 before paving stress absorbed layer, should check the quality of the grass-roots, does not conform to the requirements of paving stress absorbing layer is not allowed 　　1.2 基层必须彻底清扫干净，对有破损的情况进行处理 1.2 must be thoroughly clean at the grassroots level to deal with there is any breakage situation 　　1.3 沥青加工及沥青混合料施工温度应根据沥青标号、粘度及气候条件确定 1.3 construction of asphalt and asphalt mixture temperature should be determined according to the asphalt grade, viscosity, and climate conditions 　　2 混合料的拌制 Two mixing 　　2.1 沥青混合料宜在沥青拌和厂（场、站）采用拌和机械拌制