四层框架结构办公楼设计毕业论文.docVIP

四层框架结构办公楼设计毕业论文 江苏科技大学 本 科 毕 业 设 计 学 院 土木工程与建筑学院 专 业 土 木 工 程 系 学生姓名 班级学号 指导教师 二零一三年六月 江苏科技大学本科毕业设计 苏南人才市场办公楼设计 Design of a Talent market Office Building of South of Jiangsu 摘要 本工程为苏南人才市场办公楼四层框架结构底层层高45m办公区二层层高42米其他层层高均为36米总高度为153m建筑总面积为6096m2经过细致的方案论证我们决定上部结构采用纵横向承重的钢筋混凝土框架结构因为该工程抗震设防烈度为7度所以不考虑竖向地震作用在用底部剪力法求出水平地震作用后利用D值法完成了水平地震作用下的一榀框架的内力组合计算采用二次弯矩分配法分别完成了恒载和活载最不利布置作用下的内力计算接着进行结构构件的地震作用效应与其它荷载效应的基本组合及无地震作用效应与其它荷载效应的基本组合两种情况对框架内力进行组合得出框架梁柱的控制内力进而完成了梁柱截面的配筋计算进行了独立基础的计算及零星构件的计算用天正72013AutoCAD2010PKPM2005软件等计算并绘制本工程建筑和结构施工图 关键词地震框架结构二次弯矩分配法荷载内力组合截面设计办公楼 Abstract This project is a building of office of The talent market of South of Jiangsu This subject is four stories frame structure The first Storey is 45m and the second story of administrative area is com other stories are 36m The total height of 153m The total building area of this project is 6096m2After complicated analysis the frame structure of supporting weight in lengthways and transverse direction of reinforced concrete is adopted for the superstructure of this building As the anti-earthquake degree is 7vertical earthquake is skipped After the horizontal earthquake is calculated by the bottom-shear method the Value D method is applied to calculate the stress of a frame under horizontal earthquake Then the stress under vertical dead load and the most adverse-arrange live load is calculated by the double-moment-divided method Considering the two cases the basic combination of the earthquake and the load and the basic combination of the load and no earthquake the load effect combination is carried off So according to the stress and of beams and columns the section design is finished The calculation of the independent foundation and other members are carried on The software of Tianzheng2013AutoCAD 2010 and PKPM2005 is applied to calculation and draw the pi