毛竹材性差异对胶合竹层板应力分级的影响.pdf

安徽农业大学学报, 2017, 44(2): 260-264 Journal of Anhui Agricultural University [DOI] 10.13610/ki.1672-352x030 网络出版时间：2017/4/19 12:04:43 [URL] /kcms/detail/34.1162.S1204.060.html 毛竹材性差异对胶合竹层板应力分级的影响 1 2 2 2 3 严 彦 ，刘焕荣 ，张秀标 ，陈国宁 ，武 恒 (1. 安徽太平试验中心，太平 245716 ；2. 国际竹藤中心，北京 100102 ；3. 安徽农业大学林学与园林学院，合肥 230036) 摘 要：通过测试不同杆高部位毛竹竹材的密度、抗弯强度及弹性模量，采用不同杆高部位的竹条制备胶合竹 层板，并以抗弯弹性模量为指标对其进行分级，初步研究了不同杆高部位材性的差异对胶合竹层板分级的影响。结 果表明，毛竹气干密度从基部至梢部呈现增大趋势，杆高3～9 m 处密度增大趋势较缓，气干密度值相近。毛竹抗 弯强度及弹性模量从基部至梢部呈现增大趋势，梢部性能最优，其中杆高1～5 m 部位竹材性能接近，杆高5～9 m 部位性能接近；胶合竹层板E-Rated 级别与竹材抗弯强度及弹性模量密切相关，相对应E-Rated 级别由低到高大致 可分为4 级。 关键词：胶合竹层板；抗弯强度；抗弯弹性模量；E-Rated 分级 中图分类号：S785 文献标识码：A 文章编号：1672352X (2017)02026005 The effect of Phyllostachys pubescens f.lutea Wen property on the E-Rated classification of laminated bamboo board 1 2 2 2 3 YAN Yan , LIU Huanrong , ZHANG Xiubiao , CHEN Guoning , WU Heng (1. Anhui Taiping Experimental Station, Taiping 245716;2. International Center for Bamboo and Rattan, Beijing 100102; 3. School of Forestry and Landscape Architecture, Anhui Agricultural University, Hefei 230036) Abstract: The paper analyzed the influence of materials in different positions of bamboo culm on the E-Rated classification of laminated bamboo board. We tested the density, bending strength and modulus from the bottom up to the bamboo culm. Laminated bamboo board was graded according to bending modules made from strips in different locations of bamboo culm. We found that the density, bending strength and modulus increased from the bottom to up of a bamboo culm. The density fluctuated gently between 3 and 9 m, a